Contents About Heyrex......................3 Contents of the Box....................4 The Hardware......................5 Se ng up your Heyrex Monitoring System..............6 Setup Diagram......................8 Changing the Ba$eries....................9 Troubleshoo'ng and Support...................10 Warranty Informa'on....................10 Compliance Informa'on..................11/12 support@heyrex.com...
With Heyrex your dog’s profile can be linked to your vet for even greater peace of mind. Heyrex can automa'cally advise your vet of any behaviour changes your dog encounters.
The Receiver is an Ethernet device that plugs into your router or modem and communicates with the Heyrex biosensor wirelessly. When a biosensor comes within range of a Receiver it will transfer all of its stored informa'on to that Receiver which then uploads it to the Heyrex servers, via your internet connec'on.
Se ng up your Heyrex Monitoring System You must go to www.heyrex.com/setup to complete your setup online. Please DO NOT setup or plug in any hardware un'l the online setup instruc'ons advise you to do so. Step One: Create your account. Enter your details as the owner of the dog.
Page 8
Heyrex clinic. Step Seven: If you are leasing your Heyrex from your vet hospital, once you agree to the terms & condi'ons your set-up is complete. If you own your Heyrex you will be...
For a video clip showing how to change the ba$eries please go to www.heyrex.com/support They Heyrex biosensor capsule takes two (2) CR2032 ba$eries. These can be purchased at most ba$ery outlets and supermarkets. Step One: Remove the biosensor from the surround Step Two: Turn the biosensor capsule and casing over so you are looking at the back side (without the Heyrex logo).
This online sec'on is an informa'on hub which should answer any of your ques'ons and includes videos for your reference. If you wish to contact Heyrex Ltd please do so at support@heyrex.com Warranty Informa'on Your Heyrex hardware comes with a 12-month limited warranty.
FCC Warnings for Receiver Model R4 (FCC ID: RGZ-R4). Changes or modifica'ons not expressly approved by Heyrex Limited could void the user’s authority to operate the equipment. The device must be used with the antenna supplied. Do not connect other antennas, amplifiers or RF equipment to this device.
Page 13
Cet équipement doit être installé et u'lisé à une distance minimale de 20 cm entre le radiateur et votre corps.
Page 14
FCC Warnings for Biosensor Model C7 (FCC ID: RGZ-C7). Changes or modifica'ons not expressly approved by Heyrex Limited could void the user’s authority to operate the equipment This device complies with Part 15 of the FCC Rules. Opera'on is subject to the following two condi'ons:...
Need help?
Do you have a question about the R4 and is the answer not in the manual?
Questions and answers