Exi RoamAlert User Manual

Long range proximity detection device

Advertisement

Quick Links

Installation & User Manual
May 2000
© Copyright 2000, EXI Wireless Systems Inc. All rights reserved.
Revision 1.0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RoamAlert and is the answer not in the manual?

Questions and answers

Summary of Contents for Exi RoamAlert

  • Page 1 Installation & User Manual May 2000 © Copyright 2000, EXI Wireless Systems Inc. All rights reserved. Revision 1.0...
  • Page 2: Table Of Contents

    EXI ECO-Lite User Manual 980-000004-000 Table of Contents Limited Warranty..........................3 Record of Changes..........................4 FCC Regulations ........................... 5 Introduction............................6 Initializing the ECO-Lite System ......................7 ECO-Lite Controller ..........................8 Wireless Keypad ........................... 9 Bypassing / Escorting Patients ......................9 Accepting Alarms ..........................
  • Page 3: Limited Warranty

    Product(s). The responsibility of EXI under this warranty is and shall be limited to repairing or replacing the Product(s) or any part thereof determined by EXI in its sole discretion to be defective in workmanship or material.
  • Page 4: Record Of Changes

    EXI ECO-Lite User Manual 980-000004-000 2. Record of Changes May 2000 Revision 1.0 Initial Release EXI Wireless Systems May 2000 Revision 1.0...
  • Page 5: Fcc Regulations

    EXI ECO-Lite User Manual 980-000004-000 3. FCC Regulations This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference re- ceived, including interference that may cause undesired operation.
  • Page 6: Introduction

    4. Introduction ECO-Lite is a long range proximity detection device usually used as a departure alarm. ECO-Lite detects the presence of EXI wrist or asset transponders within a prescribed detection zone. ECO-Lite may be used • Alert if people of property at risk are near an egress or danger zone.
  • Page 7: Initializing The Eco-Lite System

    EXI ECO-Lite User Manual 980-000004-000 5. Initializing the ECO-Lite System Before using the ECO-Lite System, the wireless keypad must be configured to communicate with the con- troller. The following procedure follows: Plug in the 24V AC adapter into the controller power jack.
  • Page 8: Eco-Lite Controller

    EXI ECO-Lite User Manual 980-000004-000 6. ECO-Lite Controller The ECO-Lite has 3 lights to indicate status: Green Yellow (Standby) (Bypass) (Alarm) Front View • “GREEN LIGHT” indicates the power is on and the system is on standby. • “RED LIGHT” FLASHING indicates an alarm is in progress (tag detected in range).
  • Page 9: Wireless Keypad

    EXI ECO-Lite User Manual 980-000004-000 7. Wireless Keypad The Wireless Keypad has 2 lights to indicate its status: LITHIUM BATTERY 8 POSITION ROTARY SWITCH BYPASS (Green) BATTERY LOW (Red) Back View Front View • BYPASS (Green) Light will flash when the bypass code is entered.
  • Page 10: Password Management

    EXI ECO-Lite User Manual 980-000004-000 10. Password Management There are two types of passwords: Master password and User password. Master password is used to assign or delete User password. User passwords are used to bypass the system. There is only one Master password and 2 user passwords. All passwords are 4 digit numbers.
  • Page 11: Operational Mode Change

    EXI ECO-Lite User Manual 980-000004-000 11. Operational Mode Change To change the operation mode: 1. Enter Master Password 2. Press ‘ENTER’ key 3. Enter code for mode of operation: • “51” Test Mode • “52” Normal Mode with Unlimited Alarm Duration •...
  • Page 12: Assigning The Keypad To The Controller

    EXI ECO-Lite User Manual 980-000004-000 13. Assigning the Keypad to the Controller The Keypad can only communicate to the Controller if they both have the same ID number. Each Keypad and Controller comes with 8-position rotary switch, which is used to set this ID number. Multiple Control- lers could be programmed to respond to the same Keypad or multiple Keypads could be used to send com- mands to the same Controller (their ID settings should be the same).
  • Page 13: Controller Enclosure

    EXI ECO-Lite User Manual 980-000004-000 17. Controller Enclosure The best position for this Controller is to be installed above the door (best field coverage). The controller is mounted to the wall by two mounting tabs. 18. Wireless Keypad Enclosure The base plate of the keypad is mounted to the wall with 4 screws and the keypad face plate simply snaps onto this base plate.

Table of Contents