Download Print this page

Colorado time systems Dolphin Setup

Wireless stopwatch timing system
Hide thumbs Also See for Dolphin:

Advertisement

Quick Links

Dolphin Wireless Stopwatch Timing System Set Up
Configure Software/Base
Connect base unit to laptop with USB cable. Open Hy-Tek Meet Manager, and open Dolphin
from the Interface menu on the Run screen. In the Dolphin interface, set the channel on the base
by clicking the Channel box and selecting the desired channel.
Configure starter:
TRIG = CTS for use with CTS electronic start system
TRIG = NC for use with a normally-closed electronic start system
Select CHAN to set channel number. The starter must be on the same
channel as the base.
(See How to Change Settings for details)
Configure lane watches:
Set LANE (1-10) and TIMER (A, B or C) for each watch.
Select CHAN to set channel number. All watches must be on the same
channel as the starter and the base.
(See How to Change Settings for details)
HOW TO CHANGE SETTINGS: Press and hold Reset and immediately press the Start/Stop
button. Hold them both until unit enters the menu. Release the Reset button and then the
Start/Stop button.
Press the Start/Stop button to change the setting for the current menu option.
Press Reset to advance to the next menu option.
Accessories and Replacement Parts
R-1004-0505
Base
R-1004-0506
Watch
R-1004-0507
Starter
R-015-569
USB cable
K-DSS-1
Kit- Starter to CTS Infinity start system
K-DSS-2
Kit- Starter to CTS Champ Start
R-045-011
Hard-sided carrying case (holds up to 27 devices)
Battery: 9-volt; provides 40+ hours of operation.
NOTE: When not in use, the Dolphin system should be stored away from the pool deck to
minimize
corrosion.
Phone: 970-667-1000 x256 Fax: 970-667-1032 Toll free: 800-287-0653 ext. 256
Colorado Time Systems
th
1551 E. 11
Street, Loveland, CO 80537
www.coloradotime.com E-mail: customerservice@coloradotime.com
ON/OFF: Press and
hold the Reset button to
turn watches and starter
on or off.
F911 Rev. 0707

Advertisement

loading
Need help?

Need help?

Do you have a question about the Dolphin and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Colorado time systems Dolphin

  • Page 1 Connect base unit to laptop with USB cable. Open Hy-Tek Meet Manager, and open Dolphin from the Interface menu on the Run screen. In the Dolphin interface, set the channel on the base by clicking the Channel box and selecting the desired channel.
  • Page 2 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Patent Pending Colorado Time Systems Phone: 970-667-1000 x256 www.coloradotime.com...