MOCK Mockmill 100 Operating Instructions Manual page 11

Opening the milling chamber
3
You can now open the milling chamber
by unscrewing the large round cap
with the cross in the middle counter-
clockwise.
Remove Stator
4
Now you can remove the top stone
(stator). The bottom stone (rotor) is
now visible and is attached to the
motor shaft. If a hard film has built
up on the milling stones please see
p. 7. this will explain how it can be
removed. The top stone (stator) can
now be put back on.
Closing the milling chamber
5
Screw the large round cap back on
again, 2 - 3 turns until you feel a strong
resistance. Now turn the cap one
quarter-turn back. Plug the Mockmill
back in and turn on. Turn the cap
further until you hear a slight ticking
noise.
DE
EN
11