Traxxas Aton Receiver Installation Instructions

Receiver Installation Instructions
Note: The Āton 2.4GHz Receiver (part #7992) can only be used
with the Āton Quad-Rotor Helicopters (part #7908, 7909).
Note: Retain and reuse all parts and fasteners (unless otherwise
noted).
1. Remove the 2.6x8mm button-head cap screws (2) to remove
the canopy from the helicopter (A).
2. Remove the 2.6x8mm button-head cap screws (3) and
rubber isolators (3) from the receiver assembly (B).
3. Remove the 2.6x8mm button-head cap screws (2) from the
receiver support frame (B).
4. Disconnect all wiring from the receiver assembly. Take
note of all connector locations and orientation before
disconnection.
5. Unsnap the beeper from the receiver support frame.
6. Remove the receiver assembly from the helicopter and
discard.
7. Installation of the new receiver assembly is the reverse of
removal.
FCC Compliance
This device complies with the limits for a Class B digital device as
described in part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
The limits for a Class B digital device are designed to provide
reasonable protection against harmful interference in residential
settings. This equipment generates, uses, and can radiate
radio frequency energy and, if not operated in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. The user is cautioned that
changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
Canada, Industry Canada (IC)
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada license exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
Radio Frequency (RF) Exposure Statement
This equipment complies with radio frequency exposure limits
set forth by FCC and Industry Canada for an uncontrolled
environment. This equipment should be installed and operated
with a minimum distance of 20 centimeters between the radiator
and your body or bystanders and must not be co-located or
operated in conjunction with any other antenna or transmitter.
End Product Labeling
This module is marked with an FCC ID and IC certification number.
The host system using this module must be labeled in a visible
area with the following: "Contains FCC ID: XVE-TRX1020,
IC: 8668A-TRX1020". This LMA is tested and approved as a stand-
alone configuration. Additional evaluation may be required for
any system integrated with this radio module. This module and its
antenna should not be installed or operated in conjunction with
any other transmitter.
Traxxas, 6250 Traxxas Way, McKinney, TX 75070, Phone: 972-549-3000, Fax: 972-549-3011, e-mail: support@Traxxas.com
A
Receiver assembly
2.6x8mm BCS
B
2.6x8mm BCS
Rubber isolator
Beeper
If you have questions or need technical assistance, call Traxxas at
1-888-TRAXXAS
TR A X X A S. c o m
Canopy
Receiver support frame
(1-888-872-9927) (U.S. residents only)
Covers Part #7992
KC2399-R00 Rev 160324