Advertisement
Quick Links
S110 Steel Level Panel Installation Instructions
NOTE: Fairway Architectural Railing Solutions will not be held liable for incorrect or unsafe installations by
installer. It is the installer's resposibility to secure proper building permits, review local codes and safety needs
and meet or exceed them. The instructions provided by Fairway are a guide and may not account for every
special circumstance. The installer must identify and execute the installation approach that is appropriate for
every application
STEP 1 - Install S110 Flanged Steel Post* for Wood and Composite Decking, and Concrete
Surface
(S110 steel flanged post, cap & trim kit sold separately from level panel.)
• Determine placement of post on deck or concrete surface. Set post in place and mark mounting holes.
• Mount post to surface using one of the options and suggested mounting hardware pictured below.
NOTE: Installer must determine the proper mounting hardware (sold separately) based on application.
• Check fit of rail between mounting surfaces.
NOTE: Wood posts can be substituted for steel posts. (Installation instructions not included.)
Advertisement
Summary of Contents for FAIRWAY ARCHITECTURAL RAILING SOLUTIONS S110
- Page 1 S110 Steel Level Panel Installation Instructions NOTE: Fairway Architectural Railing Solutions will not be held liable for incorrect or unsafe installations by installer. It is the installer’s resposibility to secure proper building permits, review local codes and safety needs and meet or exceed them. The instructions provided by Fairway are a guide and may not account for every special circumstance.
- Page 2 • Place rail assembly between posts and install brackets using provided T-25 screws. Use low speed setting on drill. • Predrill pilot holes and secure rails with provided set screws on the side of each bracket. ©2018 FAIRWAY ARCHITECTURAL RAILING SOLUTIONS.
- Page 3 S110 Steel Adjustable Stair Panel Installation Instructions NOTE: Fairway Architectural Railing Solutions will not be held liable for incorrect or unsafe installations by installer. It is the installer’s resposibility to secure proper building permits, review local codes and safety needs and meet or exceed them.
- Page 4 STEP 2 – Line Up Stair Panel • Using support blocks on the top and bottom step to ensure proper rail sweep height, set bottom rail onto support blocks and rake panel so that the balusters are parallel with post. •...
- Page 5 Line up brackets with bracket plate and replace hinge pin. • Check fit of panel and adjust as necessary. • Pre-drill using 3/16” drill bit at rail screw location on side of bracket. • Install Provided T-25 screw. ©2018 FAIRWAY ARCHITECTURAL RAILING SOLUTIONS.