Advertisement
SAWRemote Handheld Touchpads
Note: If you wish to use a sensor number other than
the next available, enter a 2 digit sensor number with
the red numbered keys immediately after entering the
sensor type.
7.
Press and hold the 2 emergency buttons to trip
the sensor.
Testing Remote Handheld
Touchpads
Perform Sensor Test
The following steps describe the guidelines for test-
ing sensors.
1.
Open the Control Panel cover.
2.
Enter the Utility Access Code 1 or 2 using the
red-numbered buttons.
3.
Press the Test button once.
4.
Press DONE.
5.
Trip the sensor by pressing the 2 emergency
buttons until the Control Panel indicates the
number of RF packets received.
6.
Note the number of siren beeps indicating how
many RF packets the Control Panel received
from the sensor. You should hear 7-8 beeps.
Test Touchpad operation by pressing the buttons as
described below:
1.
Numeric Buttons (0 - 9) - Used to enter an
access code or turn individual lights on or off.
2.
Disarm Button -The Control Panel is disarmed
to level 1. Doors, Windows, and Motion Sen-
sors are disarmed. Disarm also requires the
access code to be entered.
3.
ARM Doors & Windows Button - The Control
Panel is armed to level 2.
4.
ARM Motion Sensors Button - The Control
Panel is armed to level 3. If the ARM Doors
& Windows button was previously pressed, the
Control Panel is armed to level 4 (Doors/Win-
dows and Motion Sensors armed).
5.
On Lights Button - Pressing this button twice
quickly activates all lights controlled by the
system. Or when pressed once and used with
the Numeric Buttons can turn specific lights
on.
Page 2
6.
Off Lights Button - Pressing this button twice
quickly turns off all lights controlled by the
system. Or when pressed once and used with
the Numeric Buttons can turn specific lights
off.
7.
Emergency Buttons - If learned in as sensor
type 01-Intrusion, 03-Silent, 06 or 07-Emer-
gency, when pressed simultaneously, will acti-
vate alarm reports to the central station.
Specifications
Power source: 2 AAA Alkaline batteries
Typical battery life: 1 year
Operating temperature range: 10° to 120° F
Dimensions: L = 4.88" x W = 2.25" x H =.88"
FCC NOTICE
This device complies with FCC Rules Part 15. operation is subject to the following two
conditions:
1) This may not cause harmful interference.
2) This device must accept any interference that may be received, including interfer-
ence that may cause undesired operation.
Changes or modifications not expressly approved by Interactive Technologies, Inc. can
void the user's authority to operate the equipment.
6 5 1 - 7 7 7 - 2 6 9 0
6 5 1 - 7 7 9 - 4 8 9 0
Advertisement
