Sony MZ-E55 Service Manual page 12

* Remote commander display during automatic adjustment
057
Mode No. under adjustment
4. If result of automatic adjustment is OK, the following display
appears.
0 4 7
End-OK
5. If result of automatic adjustment is NG, the following display
appears.
0 51
NG
Error code
NG mode No.
* If NG, enter servo mode to perform automatic adjustment of the
item determined as NG.
Adjustment in Servo Mode Method
1. When each adjustment mode is set according to the structure of
servo mode, the lower two digits of the mode No. and the ad-
justment value written in EEPROM are displayed and lit on the
LCD on the remote commander.
052
Mode No.
2. When the P key is pressed, the following display appears and
the automatic adjustment is performed.
0 52
Adjustment value (flashing)
Although the VOLUME +/– keys can be used to change
Note)
the adjustment value to any value, they should not be
used whenever possible.
3. When the automatic adjustment is completed, the flashing ad-
justment value is lit.
0 52
Adjustment value (flashing)
Adjustment value (lit)
Adjustment value (lit)
– 12 –