Advertisement
Quick Links
PRODUCT WARRANTY
The ARTOGRAPH Projector Floor Stand is warranted to be free from defects in material
and workmanship for ONE YEAR from the date of purchase by the consumer. Any part
of the equipment found to be defective under normal installation and use during the
warranty period will be repaired or replaced by ARTOGRAPH. The equipment should
be returned, postage or freight prepaid, to ARTOGRAPH and must be accompanied
by a proof of purchase. CONTACT OUR OFFICE, PRIOR TO RETURNING, FOR
RETURN AUTHORIZATION.
Equipment repaired or replaced under warranty will be returned freight or postage
prepaid. The warranty for repaired or replacement parts shall be for the duration of the
original warranty. This warranty does not apply to equipment which has been subjected
to abuse, accident, or alteration.
If you need more information or help, please contact your local dealer,
or contact Artograph at:
Toll-free: (888) 975-9555 Tel: (763) 553-1112
Fax: (763) 553-1262
Plug into your creativity at www.artograph.com
Made in the USA
2838 Vicksburg Lane North, Plymouth, MN 55447-1878
306-205
Artograph, Inc.
Plymouth, MN
Email: info@artograph.com
User's Guide
User's Guide
Projector Floor Stand
Projector Floor Stand
2838 Vicksburg Lane North, Plymouth, MN 55447
2/07
Plug into your creativity at
#225-350
www.artograph.com
Advertisement
Related Manuals for artograph 225-350
Summary of Contents for artograph 225-350
- Page 1 User's Guide PRODUCT WARRANTY User's Guide The ARTOGRAPH Projector Floor Stand is warranted to be free from defects in material Projector Floor Stand Projector Floor Stand and workmanship for ONE YEAR from the date of purchase by the consumer. Any part of the equipment found to be defective under normal installation and use during the warranty period will be repaired or replaced by ARTOGRAPH.
-
Page 2: Parts List
Remove all parts from the box and lay them out on for purchasing the Projector Floor Stand. This stand can accommodate all Artograph projectors as well as many other types of projectors. It features a a table top or fl oor. For your convenience, the Lower... - Page 3 TRAY ASSEMBLY Spacer Figure 3 Slide a Spacer onto the round pegs (Fig. 2) located on each side of the Tray. While holding the Spacers in place, set the Tray into the slots on top of the Upper Y-Bracket (Fig. 3) so that the Spacers are sandwiched between the Tray and the Upper Y-Bracket.
- Page 4 ADJUSTING HEIGHT ADJUSTING ANGLE The floor stand height is adjustable from 3 feet to To ensure accurate image projection, it is very important approximately 4 ½ feet. To adjust the height, loosen the that the projector is perpendicular to the projection Locking Collar (Fig.
Need help?
Do you have a question about the 225-350 and is the answer not in the manual?
Questions and answers