Eddystone Short Wave Manual page 7

WIRING
PLAN-
CHASSIS
TOP
ON ES
CART0-4
Ac.
0
V2
0
EILAcK
RED
0
0
L7r
L'r
0
ItATTERY LEADS.
The end of the battery cable should be stripped of its braiding for:
about G inches and the leads Placed through the hole in the hack of chassis
and wired up :is follows :
LT.+ (Rod) to No.
Socket of VI.
LT. (nine) to Top Tag of OrtOff Switch.
11.T.
(White) to
A--
'Phone Socket.
11.T.-- (Black) to Condenser Block.
The end of the braiding tuay be bound with twine to make a neat
ending.
29
0
0
T -R ?AMER .
FIxeo
PL Arcs
10
To
OViNG
L-77.071re,
To FIXED PL A -r cS or
Conoemscp.
ALL WORLD TWO
Point to Point Connections-cont'd.
*'27
One end of .002 infd. Condenser to Grid Socket of V2.
.28.
Other end of this Condenser to Reaction Trimmer.
20
Same Connection of Trimmer, through B'in chassis, to Top Cap
of
*30
One end of 100,000 ohms Resistance to-same:Side of Trimmer.
* 31- Other end of 100,00(1 ohms Resistance to + 'Phone Socket.
:32.
- End Tag of Reaction Control to Soldering Tag E.
.33 Tag of Reaction Control to 40,000 ohms Resistance.
34- -Remaining end of 40,000 ohms Resistance to Connection No. 31.
3,5-- Filament Socket of V2 to Soldering Tag E.
36
Centre Socket of V2 to Connection No. 31.
37
Anode Socket of 1'2 to -- 'Phone Socket.
. 3t3
- One end of .002 infd. Condenser to Anode Socket of 1'2.
*:39
Other end of .002 infd. Condenser to Floss E.
No wire is necessary on these connections as contact is auto-
matically made by the tags or wire ends of the components concerned.