Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Kizy Tracking K-2
-
Page 1: User Manual
User Manual K-2 User Manual December 2017, Version 3.1... -
Page 2: General Description
Using its GSM communication unit with its embedded SIM-card, it can be localized based on connectivity information from the GSM networsk. Unlike the GPS technology, the position of the K-2 can thus be determined as long as a 2G/3G GSM reception is available. - Page 3 Light, small and robust 56 mm Light sensor, Weight: 47 gr 3 status indicators Movement sensor Temperature sensor Accelerometer Power switch QR-code and Type and USB-C tracker ID certificates connector 8.5 mm K-2 User Manual December 2017 , Version 3.1...
-
Page 4: Battery Charging
Once charged, remove the charging cable and close the protection lid. For more information on the charging and meaning of the LED status, visit the Support section support.kizytracking.com K-2 User Manual December 2017 , Version 3.1... - Page 5 • In case the tracker shows red flashing twice per second followed by six seconds of no light, the battery is low and needs to be charged. K-2 User Manual December 2017 , Version 3.1...
- Page 6 Use of QR-Code The use of K-2 is coupled to an Internet-hosted data management platform. The device-specific URL (Internet- address) of this platform can be obtained by scanning the QR- code on the front of the tracker. You may either use a dedicated scanner or you can use a smartphone application.
-
Page 7: For Your Safety
• Do not expose the tracker to weights exceeding 50 kg on its surface. unauthorized repairs. • Only use compliant USB-cables for battery charging. • Do not expose the tracker to moisture or water. K-2 User Manual December 2017 , Version 3.1... -
Page 8: Troubleshooting
The green or orange light is blinking every second while the battery charging is active. The tracker is trying to connect to the GSM-network. The charging pattern will be shown again when this is finished. K-2 User Manual December 2017 , Version 3.1... -
Page 9: Specifications
87mm x 56mm x 8.5mm Weight < 47g IP class > IP54 Certifications CE, FCC, RoHS, FSS light, motion, temperature, accelerometer Sensors support for external sensors (one-wire, I2C) Operating system embedded Linux, over-the-air configuration K-2 User Manual December 2017 , Version 3.1... - Page 10 2000 Neuchâtel Switzerland No part of this User Guide may be reproduced without written consent of Kizy Tracking. The technical data are correct at the time of submission to the certification body and may change without prior notice. K-2 User Manual December 2017 ,...
- Page 11 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ...
Need help?
Do you have a question about the K-2 and is the answer not in the manual?
Questions and answers