Dubbing From Tape To Tape; Recording From The Radio; Erasing Recorded Tapes - Sharp CD-MPS66 Operation Manual

Recording from several discs continuously:
1 Perform steps 1 - 5 in "Recording from a CD or MP3 disc" on page
30.
2 Within 5 seconds, press the /
To perform programmed recording:
1 Program discs and tracks. (See page 21, 25.)
2 Press the button.
3 Press the / .
To stop recording:
Press the button.
The disc and tape will stop.

! Recording from the radio

1
Tune in to the desired station. (See page 26.)
2
Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button.
Recording will be paused.
4
Press the / button to start recording.
To interrupt recording:
Press the button.
To resume recording, press the /
To stop recording:
Press the button.
Note:
If you hear a whistling noise while recording an AM station, move
the AM loop antenna.

! Dubbing from tape to tape

You can record from TAPE 1 to TAPE 2.
.
To stop dubbing:
Press the
TAPE 1 and TAPE 2 will simultaneously stop.

! Erasing recorded tapes

1
2
3
button.
4
Note:
Make sure that the TAPE 1 is not in use.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette
into the TAPE 1 cassette com-
partment. Insert a blank tape
into the TAPE 2 cassette com-
partment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE (1 2) button until "TAPE 1" appears on
the display.
4
Press the button.
Recording will be paused.
5
Press the / button to start dubbing.
button.
Load the tape to be erased into the TAPE 2 cassette compart-
ment with the side to be erased facing toward you.
Press the TAPE (1 2) button until "TAPE 2" appears on the dis-
play.
Press the button.
Press the / button to start erasing.
CD-MPS66
CD-MPS600
31