WaterLine Controls WLC-9000 Installation Instructions

Installation Instructions for Model WLC-9000
is the optimum choice for any situation requiring the
precise control of a water level. It is ideal for automatically maintaining the
correct level in cooling towers, storage tanks, or process water applications.
Model WLC-9000 achieves control by the use of a
corrosion resistant probes that sense the water level and then in conjunction with
electronics and a microprocessor, provides signals that can be used to open/close
valves and other control or recording devices thus maintaining correct levels.
IMPORTANT SAFETY INSTRUCTIONS
1. Call the factory with any questions. 1-888-905-1892 or write to:
System Dynamics, P.O. BOX 12544, Scottsdale, AZ 85260
2. Read and follow all instructions.
3. Disconnect all power before opening the internal cover/s or making any connections to the unit.
4. Do not install in locations where sprinklers or other watering devices will allow water to impinge on the unit.
5. Sensor wires must be continuous and not spliced.
6. Make sure the unit is connected properly to earth ground.
7. Only qualified personnel should install this unit or replace the "replaceable" parts.
8. Only factory supplied parts should be used whenever a replaceable part is needed.
9. The manufacture will not be liable for any injury or damage that may arise from the misuse of this
unit or from failure to follow all of these instructions.
10. Save these instructions and provide them to the end user.
11. This unit shall not be used in any "safety critical" application or where the failure of any function or component may cause death or personal injury.
11. Ne pas utilisez cet élément quand les blessures oú la mort peuvent les présenter.
12. Use copper (CU) wire only for all connections.
Levolor is a registered trademark of Jandy Pool Products, Inc. and used under license only. SDI and Jandy Pool Products, Inc. are not affiliated companies.
Waterline Controls is a registered trademark of SDI.
Page 1
© SDI 2008