1. Manuals
  2. Brands
  3. EMIX Manuals
  4. Recording Equipment
  5. EMRM-810
  6. Owner's manual

EMIX EMRM-810 Owner's Manual

Indirect speaker selector
Hide thumbs
1
2
3
4
5

Advertisement

Table of Contents

OWNER'S MANUAL
Before operating, please read this manual completely.

FEATURES:

Professional distributor for paging.
10 inputs.
10 paging channels.
10 outputs.
10 EMRM-810 can be linked at most, they can be recognized bye binary code.
4 paging microphones with 4 classes priority as MIC1>MIC2>MIC3>MIC4.
+24V DC power supply.
Professional Public Address System
Indirect Speaker Selector
1
EMRM-810

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EMRM-810 and is the answer not in the manual?

Questions and answers

Summary of Contents for EMIX EMRM-810

  • Page 1 Before operating, please read this manual completely. FEATURES: Professional distributor for paging. 10 inputs. 10 paging channels. 10 outputs. 10 EMRM-810 can be linked at most, they can be recognized bye binary code. 4 paging microphones with 4 classes priority as MIC1>MIC2>MIC3>MIC4. +24V DC power supply.

  • Page 2: Front Panel

    FRONT PANEL: 1. AC power switch 2. Power Indicator Light (LED is bright when press Power Switch) 3. PAGING indicator( inputs active) 4. SIGNAL indicator ( output active) 5. CH1-10 Channel Select Key 6. All call button 7. All call indicator REAR PANEL AND CONNECTIONS: 9 10 11 12 13...
  • Page 3 ． + 24V DC serial output: total power should be less than 20W. ． A ddress setting: binary code for recognizing 10 units of EMRM-810. ． A udio output : to pre. amplifier or amplifier ． C OM terminal of BGM input, connecting to the COM of amplifier.
  • Page 4 1． ． ． ． Address setting: For dividing 10 units of EMRM-810, we design 6 address codes on the rear panel and recognize them bye binary system. Please refer to the pictures below: There are 3 pins in each address code, it means “1”...
  • Page 5 2． ． ． ． Operation of the CH1-10 select key: The “PAGING” indicator LED is bright when you pressed the channel select key. The equipment will send out the paging signal which comes from the paging microphone, this namely the zone is under PAGING state. By contraries, the output indicator “SIGNAL” is off when there is not output signal.

Table of Contents