Page 2
WARNING - Maximum antenna input signal is +15dBm (50mW). Under no circumstances should the R506 be directly connected to an RF transmitter or be used in close proximity to a radio transmitter of more than 25 watts. Damage to the input amplifier circuitry is readily apparent and will not be covered under warranty.
Page 3
Table of Contents Specifications Top Panel Knobs Side Panel Connections Operation Factory Service...
Page 4
Specifications 50MHz-6GHz Frequency Range: Sensitivity: 100uV Built-in telescoping antenna Antenna: Beeper, Acoustic, Vibrator, LED signal strength Alert Modes: Sensitivity and volume Controls: 5.5"H x 2.75"W x .75"D Size: 12oz rugged hard plastic case Weight: Rechargeable internal NiMH 7.2V battery pack Battery: 2 days after full charge / 8 hour charge time Operating Time:...
Page 5
Top Panel Knobs B A V The R506 has three different modes for alerting you to RF. Beeper, Acoustic and Vibrator. Beeper The unit beeps when detecting a signal. The beeper goes from slow to rapid beeping indicating the strength of signal detected. The stronger the signal the more rapid it will beep.
Page 6
LED or two left LED’s are lit is the optimal setting. Pickup distance The R506 is capable of detecting very low power devices. Following are typical pickup distances for various RF transmitters. 10mW 2.4GHz wireless camera...
Page 7
Factory Service PRODUCT WARRANTY Optoelectronics, Inc. warrants all products and accessories for one (1) year against defects in materials and workmanship to the original purchaser. Products returned for warranty service will be repaired or replaced at Optoelectronics’ option. Specifically excluded are any products returned under this warranty that upon examination, have been...
Need help?
Do you have a question about the R506 and is the answer not in the manual?
Questions and answers