Medisana MBH Instruction Manual page 24

Spa bath mat
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 19
GB
3 Operating
3.2
Changing the
battery
16
Adjustments on the pump unit
• Press the function button
at a low setting. The LED
• Press the function button
LED
on the handle blinks red.
• Press the function button
program. The unit now switches continuously between the two levels. The
LED
on the handle blinks orange.
• Press the function button
• Once you have selected the desired massage intensity, carefully step into the
bath.
• The unit switches off automatically after 20 minutes. Using the unit for more
than 30 minutes at a time is not recommended (see Safety Information).
Adjustments on the remote control
• If you want to use the infrared remote control
bath and then switch on the unit by pressing the function button
remote control.
• Do not immerse the remote control in water.
• The remote control has a suction cup on the back. If you wet this slightly, you
can attach the remote control at a convenient distance on the bathroom wall
or on the edge of the bath.
• The remote control
handle of the pump unit
• The three levels of massage intensity can be set with the remote control
the same order as described under Adjustments on the pump unit.
- SWITCH ON UNIT
- LOW LEVEL
- HIGH LEVEL
- INTERVAL MASSAGE PROGRAMME
- SWITCH OFF UNIT
• The unit switches off automatically after 20 minutes. Using the unit for more
than 30 minutes at a time is not recommended (see Safety Information). Wait
at least 10 minutes before switching the unit on again.
The remote control
battery compartment
battery compartment cover with a suitable coin. Take out the old battery and
replace it with a new 3V CR2032 lithium battery. Ensure that it is inserted correctly
- with the plus pole to the top. Close the battery compartment
once. The unit switches on and works immediately
on the handle blinks green.
again. The unit now works at a higher level. The
one more time to use the interval massage
a fourth time to switch the unit off.
only works if it points at the infrared sensor
.
uses one 3V CR2032 lithium battery. It is located in the
on the rear of the unit. To change the battery, open the
, first climb carefully into the
on the
on the
using a coin.
in

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents