Harbor Freight Tools 91280 Assembly And Operating Instructions Manual page 6

NOTE: For additional references to the parts listed on the following pages, refer to the
Assembly Diagram (page 9).
1. The Hand Wheel (17) on the Propane Torch controls the Torch's gas flow. Turn
the Propane Torch's Hand Wheel clockwise all the way to its "OFF" position.
(See Figure A.)
2. Wrap about 4" of pipe thread sealer tape around the Torch's Cylinder Connector
(1). Then, screw the Propane Torch's Cylinder Connector (1) counterclockwise
firmly into the propane cylinder's outlet valve.
(See Figure A.)
3. Open the outlet valve on the propane cylinder first. Check for any propane leaks.
Then, slowly turn the Propane Torch's Hand Wheel (17) counterclockwise to its
"ON" position. (See Figure A.)
4. To light the Propane Torch, insert the lit end of a commercial, long handled,
fireplace/barbecue grill lighter (not included) through the slots located on
the two Nozzle Bases (36) of the Torch.
(See Figure A.)
5. Adjust the flame to the desired level by turning the Hand Wheel (17).
NOTE: The lit Nozzles (35) should operate with a blue flame with a small yellow
tip. If necessary, adjust the flame if there is sputtering or popping.
(See Figure A.)
6. To intensify the size of the flame, squeeze the Lever (28). Releasing the
Lever will bring the flame back to its previous size. (See Figure A.)
CYLINDER CONNECTOR (1)
SKU 91280 For technical questions, please call 1-800-444-3353.
ASSEMBLY INSTRUCTIONS
HAND WHEEL (17)
LEVER
(28)
FIGURE A
NOZZLE
(35)
NOZZLE
BASE
(36)
BELL (37)
PAGE 6