Table of Contents
Advertisement
(5)
Twist the strands of each wire and form them into loops large
enough to encircle the terminal screws on the back of the
controller. Then lightly tin each loop with solder.
(6)
Referring to your notes of the wire color at each terminal
on the rotator plug, connect the wires to the terminais on
the controller so that the wire from each terminal on the
rotator plug connects to the terminal with the same number
on the controller, ie., 1 to 1, 2 to 2, etc.
CONTROLLER
(7)
On the controller, make sure that the POWER switch is in
the OFF position, and that the BRAKE switch is in the
LOCK position. Then connect the line cord to the AC power
outlet.
(8)
Turn on the POWER switch. The pilot lamps should light,
and the direction indicator move to the presetting position
(360°) and stop.
(9)
Set the BRAKE switch to RELEASE, and confirm that a
click is heard in the rotator.
(10)
Press the LEFT switch, and confirm that the rotator and
direction indicator turn counterclockwise together. Release
the LEFT switch and confirm that the rotator slowly stops.
-
5 -
Advertisement
Table of Contents
