Changing The Default Standby Time; Shutting Down The Watch; Return To Factory Settings; Booting Failsafe Firmware (Fsfw) - KAIROS MSW115 User Manual

2.6.

CHANGING THE DEFAULT STANDBY TIME


To save power, your watch's screen will turn off after 10 seconds without input. To change the default
standby time, follows these simple instructions:

Enter the Standby Time sub-menu located under "Settings".

The first screen indicates the current standby time.

Swipe up or down to adjust the time as you desire.
2.7.

SHUTTING DOWN THE WATCH


If you don't want to use your watch for a certain period of time, you can shut it off to save battery.

Tap on the Shutdown sub-menu located under "Settings". This will bring shutdown confirmation screen.

Swipe right to confirm or cancel by swiping left.

To turn the watch on again, tap on the screen and hold for a moment.
2.8.

RETURN TO FACTORY SETTINGS


If you want to restore your watch to its default factory settings, you can do so by tapping the Factory
Reset sub-menu under "Settings". This will bring up the factory reset confirmation screen.

Swipe right to confirm or cancel by swiping left.

Note that after a factory reset, your watch will restart.
2.9.

BOOTING FAILSAFE FIRMWARE (FSFW)


If your watch begins to malfunction, booting FSFW will restart your watch in safe mode.

Be advised that this option should only be used if necessary as reverting to normal mode will require a
firmware upgrade.
2.10.

UPGRADING FIRMWARE


Your watch must be connected to a charger and have at least 50% battery to perform a firmware upgrade

Connect your watch to your mobile device.

Select "Firmware Upgrade" from your mobile app's side menu and follow the prompts.
2.11.

WHY DOESN'T MY WATCH SHOW ANY NOTIFICATIONS?


There are a few reasons why your watch might not display notifications.

First, make sure that Bluetooth is turned ON and that your mobile device is connected.

Second, make sure that Do-Not-Disturb (DND) mode is turned OFF.

Third, check the notification settings on the app on your mobile device.
2.12.

WHY IS MY BATTERY INDICATOR INCORRECT?


When you first boot your watch, the battery indicator will read correctly.

Charge your battery to 100% and wait until the battery indicator symbol disappears.
2.13.

WHY WON'T MY WATCH CONNECT WITH THE KAIROS MOBILE APP?


If your watch is already paired, you need to unpair it using the Bluetooth settings on both the connected
mobile device, and the watch.

Switch Bluetooth OFF and then ON again at both ends and then try to pair again.
User manual - Mechanical smart watch Page 8 of 12