Table of Contents
Advertisement
Quick Links
SZ-ESW02N, SZ-ESW02, SZ-BSW02N Power on/off Switch Installation Guide
This is an electrical power measuring device, which is compatible with ZigBee enabled devices with its embedded radio
frequency (RF) technology. It can also be used with other devices with the ZigBee logo regardless of the manufacturer.
Furthermore, it can work as a signal repeater that will extend the wireless transmission range and increase the reliability of your
network. With a ZigBee compatible gateway and software program, you'll be able to monitor and inform the energy usage of the
connected appliance.
Specification
Radio Frequency
LED Indicator
Input Power
Max Load
Operation Temperature
Storage Temperature
Alarm
Packag
e Contents
Warnings and Cautions
•
Please install and/or use in accordance with appropriate electrical codes and regulations.
•
If you are unsure about any part of these instructions, please consult a qualified electrician.
•
To reduce the risk of overheating, do not install the device near heat sources, such as fires, boilers or heating vents.
•
Do not locate the device facing direct sunlight or humid place.
•
This instruction sheet contains important technical data. Please keep it for future reference.
LED
Power (Green)
Installation
NOTE: In order to use SZ-ESW02(N) or SZ-BSW02N in a ZigBee network, the device must be connected to the network via
ZigBee coordinator. Please refer to the instruction sheet for complete information.
1.
Put the SZ-ESW02(N) or SZ-BSW02N into a wall receptacle. Make sure the receptacle is working properly. If it is
controlled by a wall switch, please ensure it is set to ON all the time.
2.
Attach the appliance to the SZ-ESW02(N) or SZ-BSW02N.
2.4GHz
Green x 1
120V / 60Hz
15A Resistive / 400W Incandescent
0° - 40°C (32° - 104°F)
-20° - 70°C (-4° - 158°F)
Over voltage protection & Over current protection
SZ-ESW02(N) or SZ-BSW02N
ZigBee Energy Switch
On (Green) - Power On.
Blinking (Green) - The join function is being processed.
Installation & Operation Manual
SZ-E(B)SW02(N) V0.4
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Sercomm SZ-ESW02N
- Page 1 SZ-ESW02N, SZ-ESW02, SZ-BSW02N Power on/off Switch Installation Guide This is an electrical power measuring device, which is compatible with ZigBee enabled devices with its embedded radio frequency (RF) technology. It can also be used with other devices with the ZigBee logo regardless of the manufacturer.
- Page 2 Operation 2. On/Off , Pairing and alarm LED (Green) On/Off and Pairing Button MANUAL Operation: • ON/OFF: Press this button of the device to turn the appliance on/off. NOTE: The appliance will be turned Off regardless of its previous setting. Join / Leave Function Auto Joining State: A sensor that does not have a network shall search for a network that is open for joining.
- Page 3 FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 4 Canada Statement This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Need help?
Do you have a question about the SZ-ESW02N and is the answer not in the manual?
Questions and answers