Page 1
BE A IN YOUR KITCHEN K6502D - DISHWASHER K430D - 166 Bottles WASH 46db 24” BUIT-IN DISHWASHER INSTALLATION MANUAL APPLICABLE MODEL: K6502D...
Page 2
Installation Dishwasher Instructions FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM IMPORTANT BEFORE YOU BEGIN – The dishwasher Read these instructions completely and MUST be installed to allow for future removal from carefully. the enclosure if service is required.
Installation Preparation PARTS SUPPLIED: Four flat head wood screws to secure dishwasher to underside of countertop (in literature package). Screw Type 2 Top Screw type hose clamps and one drain hose. 2 Side 4 Wood Screws Drain Hose Hose Clamp Mounting Clips Mounting Clips i t n...
Page 4
Installation Preparation • The dishwasher must be installed so that the PREPARE DISHWASHER ENCLOSURE drain hose is no more than 10 feet(3.05mm) in length for proper drainage. • The dishwasher must be fully enclosed on the top, side and back, and must not support any part of the enclosure.
Page 5
Installation Preparation PREPARE ELECTRICAL WIRING WARNING: FOR PERSONAL SAFETY: Remove house fuse or open circuit breaker before beginning installation. Do not use an extension cord or adapter 1-1/2”(38.1mm) Dia plug with this appliance. Hole 3“(76.2mm) Electrical Requirements: • This appliance must be supplied with 120V / 60 Hz., 24”(609.6mm) Wall and connected to an individual properly grounded...
Installation Preparation PREPARE HOT WATER LINE: STOP • The hot water line may enter from either side, rear or floor within the shaded area shown in Fig. 6 BEFORE YOU BEGIN • The line may pass through the same hole as the Locate and set aside the package containing the electrical cable and drain hose.
Installation Instructions STEP 6 INSTALL DRAIN HOSE STEP 8 SLIDE DISHWASHER PARTIALLY INTO CABINET • Install the screw type hose clamps to the drain hose. • Install the drain hose to the drain hose installation DO NOT PUSH AGAINST FRONT PANEL WITH KNEES. hose, then tighten the screw type hose hose.
Installation Instructions STEP 9 POSITION DISHWASHER UNDER COUNTERTOP Reposition Dishwasher • Check to be sure that wires are secure under the by Grasping Both dishwasher and not pinched or in contact with door Sides With Hands springs or other dishwasher components. TIP: Check tub insulation blanket, if equipped.
Installation Instructions Open the door remove the tub cap on both sides of STEP 11 SECURE DISHWASHER the tub. Install screw through the dishwasher side TO THE COUNTERTOP hole to the wall of cabinet. Reinstall tub cap. For countertops made of wood or that will not be damaged by drilling,use Method 1.
Installation Instructions DRAIN LINE INSTALLATION STEP 12 CONNECT DRAIN LINE FOLLOW ALL LOCAL CODES • Connect drain line to air gap, waste tee or disposer AND ORDINANCES using either of the previously determined method. The drain hose molded end will fit 5/8”(15.9mm), Method 1 - Air gap with waste tee or disposer 3/4”(19.1mm) or 1”(25mm)diameter connections on the air gap, waste tee or disposer.
Installation Instructions STEP 14 CONNECT POWER STEP 15 PRE-TEST CHECKLIST SUPPLY Review this list after installing your dishwasher to avoid charges for a service call that is not covered Skip this step if equipped with power cord. by your warranty. Verify that power is turned off at the source.
Installation Instructions STEP 16 DISHWASHER WET TEST STEP 17 REPLACE TOEKICK Turn on power supply (or plug power cord into outlet, if equipped). Turn on your dishwasher (please refer to the Owner's Manual for instructions). Close door, select RINSE ONLY cycle and press START/CANCEL.
Page 14
WE TRANSFORM A SIMPLE KITCHEN INTO A PRO ONE. THIS IS WHY WE CARE ABOUT MAKING VERY HIGH PERFORMANCE RANGES AND HOODS, TO MAKE YOU FEEL LIKE A PRO AND STYLISH COOKER. DESIGN: LONDON DC - WWW.LONDON-DC.COM FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM...
Need help?
Do you have a question about the K6502D and is the answer not in the manual?
Questions and answers