Advertisement
All manuals and user guides at all-guides.com
Fax +1 305 430 9692
PRODUCT DESCRIPTION
This unit is equipped with a 14.4V battery pack (12 rechargeable
•
batteries of 1.2V, Ni-Mh type, 1200mA).
This unit is equipped with an overcharge protection circuit, that protects
•
the battery pack of discharging completely or from overcharging
The adapter supplied is rated 18V, 150mA. Only use with the adapter
•
supplied.
This unit is suitable for wet and dry use (you can vacuum dust, debris or
•
liquids with it)
CHARGING THE VACUUM CLEANER
Place the vacuum cleaner on the charging base (10)
•
Ensure that the socket on the base fits correctly around the charging pin
•
(12).
Plug the adapter (11) into the wall socket. The charge indicator (4) on
•
the unit lights up.
The required charging time for this appliance is 14 hours when batteries
•
are fully depleted or for the first use.
HOW TO MOUNT THE CHARGING BASE
Your vacuum cleaner comes with a charging socket (10), where to place
the unit for it to recharge, and which holds the nozzles. A special bracket is
also included, to hold the long tubes (16) (Fig 1).
To mount the bracket, place it against the wall in the desired position,
•
and then trace the mounting holes of the bracket, by using a sharp
pencil, on the wall or the mounting surface. Make sure the wall bracket
is positioned so that the tubes can hang vertically (the 2 marks shall be
drawn along a horizontal line).
Drill a hole at each of the marked positions, with a diameter adapted to
•
the anchors and screws used. Insert an anchor into each hole.
Note: please make sure to use anchors adapted to the wall you are
mounting the bracket onto. The anchors supplied may not be adapted
to the wall material you are mounting the bracket onto.
Place the bracket (16) at the back of the charging socket (10), by
•
aligning and inserting the pins on the bracket into the back of the
charging socket. Drive one screw into each anchor, leaving the end of
the crew exposed (do not drive the screw all the way into the anchor)
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
5
Assembly page 5/12
CMN KS 36731 - 111215
Advertisement
