Advertisement
Quick Links
Drifter™ Installation Instructions
DRIFTER™
Diameter: 10.00" inches
Height: 2.87" inches
Weight – 6 Lbs.
Fig. 1
Mounting Kit:
Short screw:
.75"-1.25" surface thickness
Long screw:
1.25"-1.50" surface thickness
Instructions for use:
1. Place Drifter at the location for use. Disengage the magnetic catch, uncoil the cord from the base and plug
into a standard 120V power source.
2. To store the unit, wind the cord around the feet and engage the magnetic catch.
Instructions for securing:
1. If you are securing the Drifter to the work surface, select the correct Thumb screw for the surface thickness
(Fig. 1). Next, place the washer and plate over the screw in that order (Fig. 2), and from below the work surface
thread the screw into the anchor stud. Tighten the thumbscrew until the Drifter is secure.
10 Mountain View Drive
© ECA– October 2013—Product specifications subject to change without notice
and Technical Information
Moun ng Plate
Washer
Thumb screw
•
Shelton, CT 06484 •
Innovative Power + Data Solutions
P:800.521.3175
•
F:203.924.6687
INSTALL-DRIFTER-101413
Fig. 2
•
www.electri-cable.com
1
Advertisement
Summary of Contents for Spectrum Drifter
- Page 1 Thumb screw Instructions for use: 1. Place Drifter at the location for use. Disengage the magnetic catch, uncoil the cord from the base and plug into a standard 120V power source. 2. To store the unit, wind the cord around the feet and engage the magnetic catch.
- Page 2 Retain Instructions · Retain this instruction sheet for future use. Never use in a wet environment. Never allow liquid of any kind to spill onto or enter any part of the Drifter. Follow Warnings· Read and follow all warnings and directions in this instruction sheet and marked on Equipment.