STORE IDLE EQUIPMENT. When not in use, tools and equipment should be stored in a dry location to inhibit rust. Always lock up tools and equipment, and keep out of reach of children. REV 01/04 SKU 90723 PAGE 2...
Page 3
WARNING! The warnings, precautions, and instructions discussed in this manual cannot cover all possible conditions and situations that may occur. The operator must understand that common sense and caution are factors, which cannot be built into this product, but must be supplied by the operator. SKU 90723 PAGE 3...
DO NOT OPERATE THE SNOW THROWER WITH KNOWN LEAKS IN THE FUEL SYSTEM. EXCESSIVE BUILDUP OF UNBURNED FUEL GASES IN THE EXHAUST SYS- TEM CAN CREATE A POTENTIALLY EXPLOSIVE CONDITION. This buildup can occur after repeated failed start attempts, valve testing, or hot engine SKU 90723 PAGE 4...
Page 5
WARNING! People with pacemakers should consult their physician(s) before using this product. Operation of equipment using or producing electricity in close proximity to a heart pacemaker could cause interference or failure of the pace- maker. SKU 90723 PAGE 5...
FIGURE A Unscrew and remove the Fuel Tank Cap and the amount of unleaded gasoline in the Fuel Tank. If necessary, refill the Fuel Tank with unleaded gasoline. Then, replace the Fuel Tank Cap. (See Figure A.) SKU 90723 PAGE 6...
Move the Snow Thrower to the area that is to be cleared of snow. CAUTION! Make sure the area that is to be cleared is flat, level, and free of debris and other foreign materials. Do not attempt to use the Snow Thrower on steep inclines. SKU 90723 PAGE 7...
NOTE: Positioning the Handle Slipper (85) to the left will require one hand to operate the Auger Control and the other hand to operate the Traction Control. Positioning the Handle Slipper to the right allows you to operate the Auger SKU 90723 PAGE 8...
Page 9
Shift Handle (87) in the NEUTRAL position. Allow the Snow Thrower to come to a complete stop, stop the engine and remove the key. Then, store the Snow Thrower in a safe, dry location. SKU 90723 PAGE 9...
CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. SKU 90723 PAGE 10...