Advertisement
Table of Contents
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Cartek PDM
- Page 1 USER GUIDE AND INSTRUCTIONS JULY 2016...
- Page 2 CONTENTS INTRODUCTION PAGE 1 SPECIFICATION PAGE 2 INSTALLATION PAGE 3 CONTACT INFORMATION Unit 25, Mitchell Point Ensign Way, Hamble Southampton SO31 4RF UNITED KINGDOM +44(0)2380 457747 info@cartekmotorsport.com www.CARTEKMOTORSPORT.com...
- Page 3 INTRODUCTION INTRODUCTION This 4 channel Power Distribution Module (PDM) from is fully electronic and designed to replace 4 relays + 4 fuses in one, small, lightweight unit. Each channel can output 10 Amps and are fully protected against short-circuit and over current.
- Page 4 SPECIFICATION 90.0 mm 4 x 1 0 A m p s .com 10.5 mm Size: L = 90mm, W = 42mm. Weight: 80g. Positive Power terminal: M6 stud. Channel Output connections 6.3mm Male Spade Terminals Electrical Connector: Binder Flying Lead: Binder 79 3384 42 04 (2 meter long) Operational Voltage: 7v - 18v...
- Page 5 THIS PRODUCT IS DESIGNED FOR MOTORSPORT USE ONLY AND SHOULD NOT BE USED ON ROAD/STREET VEHICLES OR ON PUBLIC HIGHWAYS. NO WARRANTY IS MADE OR IMPLIED REGARDING ANY CARTEK PRODUCTS TO PROTECT USERS FROM INJURY OR DEATH. USER ASSUMES ALL RISKS.
- Page 6 When mounting the PDM, electrical contact must be made between the vehicle's chassis/earth and the metal case of the PDM at its mounting points. 12v Power Input is supplied to the PDM via the M6 electrical stud. (Do not over tighten.) Power Output connections are made using 6.3mm spade terminals.
Need help?
Do you have a question about the PDM and is the answer not in the manual?
Questions and answers