Table of Contents
Advertisement
Quick Links
ASSEMBLY AND OPERATION MANUAL
for the G2 Tracksetter
by Tidd Tech
You will find the most up to date version of this document at:
www.tiddtech.com/manuals.htm
1100 Roundhouse Road
Spooner, WI 54081
Toll Free: 1-877-843-3832
www.tiddtech.com
PN 040101-02 G2 Tracksetter, Assembly and Operation
Rev 1/2019
1
Advertisement
Table of Contents
Related Manuals for Tidd Tech G2 Tracksetter
Summary of Contents for Tidd Tech G2 Tracksetter
- Page 1 G2 Tracksetter by Tidd Tech You will find the most up to date version of this document at: www.tiddtech.com/manuals.htm 1100 Roundhouse Road Spooner, WI 54081 Toll Free: 1-877-843-3832 www.tiddtech.com PN 040101-02 G2 Tracksetter, Assembly and Operation Rev 1/2019...
- Page 2 You may have prior experience with Tidd Tech Trail Tenderizer or Snow Roller products. Please note that the G2 employs a spring trip on the Toothbar and DOES NOT HAVE A...
- Page 3 There should be play between the components that this bolt passes thru to allow for free rotation. Please note that this pivot has been PN 040101-02 G2 Tracksetter, Assembly and Operation Rev 1/2019...
- Page 4 “fat” end closest to the actuator. That way the rod (skinny) end is normally hanging down when the Tracksetter is raised. This keeps the seals inside the gas spring lubricated. Replace PN 040101-02 G2 Tracksetter, Assembly and Operation Rev 1/2019...
- Page 5 Note: You should be familiar with the G2 Trail Groomer Manual before reading this section. You may want to have that document available as you read this because it will help to understand the concepts. PN 040101-02 G2 Tracksetter, Assembly and Operation Rev 1/2019...
- Page 6 The G2 Tracksetter main pivot (the gold colored grade 8 bolt) is located just above the comb on the G2 Trail Groomer. The Tracksetter is rigidly attached to an arm that rotates about this pivot as the implement follows the undulating terrain.
- Page 7 – you basically just have to pull on the handle. The G2 Tracksetter works on the same principle! Other tracksetters have a pivot right at the center of the tracksetter (a short stubby hoe/rake handle) and must apply sufficient down force to keep the tracksetter planing on the snow, as well as a pulling force.
- Page 8 (we stock them). The sharp teeth on the G2 Tracksetter are replaceable and are identical to the teeth on the G2. Call us for replacement teeth when you need them. The center tooth acts to protect the nose of the trackshoe (very expensive to replace) and should be replaced if it wears down.
Need help?
Do you have a question about the G2 Tracksetter and is the answer not in the manual?
Questions and answers