Advertisement
Quick Links
First you must remove the metal cover, it is the weight stop, that keeps the SLDR weight from
coming through. Lift it up with small screw driver it has adhesive strip on the back, it needs to be
As you see removing the
metal stop strip will allow
you to remove the SLDR
Weight.
You can drill or re-apply foam tape
adhesive which ever you prefer,
drilling the hole in the plate, this will
make removing and replacing weights
much easier.
TaylorMade SLDR Weights
Installation Instructions
pried up.
There is a threaded hole that
can be used for head
weighting or hot melt or to
reattach the Metal Plate.
You can use the extra screw we
provide to just fill the screw hole if
you wish, it's easier and less work
than drilling out the plate. But if you
want to drill it out the instructions
below will help you.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for TaylorMade SLDR 460
Summary of Contents for TaylorMade SLDR 460
-
Page 1: Installation Instructions
TaylorMade SLDR Weights Installation Instructions First you must remove the metal cover, it is the weight stop, that keeps the SLDR weight from coming through. Lift it up with small screw driver it has adhesive strip on the back, it needs to be pried up. - Page 2 Mark the hole with a punch and drill small pilot hole. Then enlarge the hole to accept the sleeve screw. This will allow you to remove the sleeve stop and replace any weights you like. This is the finished head, please allow approx. one haft swing weight for the addition of the screw, also you can just use the screw to stop the weight from coming out and close the threaded...
Need help?
Do you have a question about the SLDR 460 and is the answer not in the manual?
Questions and answers