Advertisement
HushMat Products: Ultra Speaker Kit (Part # 10110) and Wave Breaker (Part # 82450)
Tools Needed: Household scissors or box knife, HushMat Pro Roller Part #90100, screw driver
Step 1: Remove Stock Speaker from vehicle:
Step 2: Peel brown release paper on one sheet of HushMat Ultra (Part #10110) and apply over speaker
opening as shown. Trim out center of sheet exposing the mounting hole.
Step 3: Use the round Ultra piece removed from the center speaker mounting hole from Step 2 above
and adhere this to the inside of the outer door skin directly behind the speaker opening.
Ultra "circle" cut out
from speaker hole
Speaker Installation Instructions
Speaker mounting hole
www.hushmat.com
@HushMatUSA
Advertisement
Table of Contents
Summary of Contents for HushMat 82450
- Page 1 Tools Needed: Household scissors or box knife, HushMat Pro Roller Part #90100, screw driver Step 1: Remove Stock Speaker from vehicle: Step 2: Peel brown release paper on one sheet of HushMat Ultra (Part #10110) and apply over speaker opening as shown. Trim out center of sheet exposing the mounting hole.
- Page 2 Step 4: Peel back release paper from back of one Wave Breaker pad (Part #82450) and stick the wave breaker directly on top of the round Ultra cut out you placed on the outer door skin. NOTE: No HushMat material should come in contact with Speaker magnet once the installation is complete.
Need help?
Do you have a question about the 82450 and is the answer not in the manual?
Questions and answers