Parts List - Mitsubishi Ki-15 Babs Construction Manual

Plywood:
1--3/8 x 6 x 12 ply: firewall
1--1/4 x 12 x 24 ply: ribs E & F, C2
1--3/16 x 6 x 12 ply: L.G. plates
1--1/8 x 12 x 36 ply: tank box, F1, F20, center section ribs(2), Rib 1(2),
center section L.E., ail servo mount.
4--1/8 x 12 x 48 lite ply: 8 center section ribs, F2, F6 thru F14, wheel pants, tank box end,
C1, fin platform
1–1/16 x 12 x 48 ply: wheel pants, V3
1--1/32 x 12 x 48 ply: cowl skin
1–1/64 x 12 x 48 ply: flap
Balsa sheets:
2–1 x 2 x 12: wing tips
2–1/2 x 4 x 48: pants, rudder post, fin rib 1
1–3/8 x 3 x 30: rudder top, V1, V2
4–1/4 x 3 x 48: tailcone, stab T.E., elevator tips, el trim tab, F5 upper, pants
4–3/16 x 3 x 36: F3, F4 upper & lower
15–1/8 x 3 x 48: 8 center ribs, wing jigs, outer wing ribs, stab ribs, fin & rudder ribs,
F15-F20, stab tips, shear webs.
54--3/32 x 4 x 48 light (soft) density: F14 ½, wing sheeting, fuselage sheeting,
stab sheeting, tailcone,rear sheer webs, flap core, lower wing filets
5–1/16 x 4 x 36: aileron skins, rudder base, fin sheeting, upper wing filets
1–1/32 x 3 x 36: aileron dummy L.E, aileron dummy ribs
Balsa Blocks:
2–3 x 4 x 12 blocks: cowl nosebowl
2–3/4 x 3 x 24 block : tailcone, wing saddle supports
Sticks:
1--3/8 dowel: wing rods
1--1/4 dowel: wing alignment pins
3—3/32 x ¼ x 36 hardwood: canopy stringers
1--1/2 x ¾ x 12 hardwood: antenna mast, stab support
1--1/2 sq. x 36 hardwood: L.G. mounts, tank box, wing bolt support
1—3/4" x 30" triangular stock: landing gear support
2--3/16 sq x 36. hardwood: cowl stringers
4--1/4 x ½ x 36 hardwood: center main spars
1--1/16 x 3/16 x 36 hardwood: elevator & rudder T.E.
2–1/2 x 3/8 x 36 hardwood: center forward spar
2–1/2 sq x 36: fin, rudder
3–1/2 x 1 ½ x 48 : Wing L.E., stab T.E.
1–1/2 sq x 48: stab L.E.
Babs Parts List
57