Advertisement
Quick Links
Installing your New CoxOrb Platinum Wiring Loom
Thank you for purchasing a CoxOrb Platinum wiring loom. The following information
will help you get the most from it but if you do have any queries please email us at
queries@active-tools.com or contact your local distributor.
Jumper Lead
How is it Different to Standard Looms?
Each loom is supplied with a Jumper Lead, Bulkhead Connector Mount and a Surface
Connector Mount.
Available in two lengths.
The sacrificial Jumper Lead joins the CoxOrb to the connection harness and is designed to
be easily replaced when the end connector eventually fails. It can be mounted using either
the Bulkhead Connector Mount or the Surface Connector Mount.
A.
B.
Connection Harness
Rate Lead and Magnet (Optional)
Modular Harness
Bulkhead Connector Mount
Surface Connector Mount
Impeller
Advertisement
Summary of Contents for Active Tools CoxOrb Platinum Wiring Loom
- Page 1 Installing your New CoxOrb Platinum Wiring Loom Thank you for purchasing a CoxOrb Platinum wiring loom. The following information will help you get the most from it but if you do have any queries please email us at queries@active-tools.com or contact your local distributor.
- Page 2 Selecting the Right Mount Generally we recommend using the Bulkhead Connector Mount in stern coxed boats and the Surface Connector Mount in bow coxed boats. However this can vary depending on boat type and make so we suggest you select the mount that is best suited to your boat. Installing the Bulkhead Connector Mount 1.
- Page 3 Installing the Impeller Sensor & Impeller The location of the Impeller effects the readings it gives due to the changing turbulence along the boat. We recommend that the Impeller is mounted near the cox, for convenience, and that is then automatically calibrated by your CoxOrb Platinum. 1.
Need help?
Do you have a question about the CoxOrb Platinum Wiring Loom and is the answer not in the manual?
Questions and answers