Corner Installation - DCS TDS1-20 Installation Instructions Manual

9a PREPARE THE CAVITY
Ensure the cavity is level, square and able to support the weight of the product
when full.
Any cabinet and/or ground preparation must be completed prior to installation.
All support structures must be constructed of materials resistant to moisture
damage.
Do no use harsh products (acid, solvent, sealers) around this product.
1 Depending on your construction, place either a shelf or at least two
(min 2" (51 mm) wide) moisture resistant supports in the cutout.
Ensure all support boards are flat and level.

CORNER INSTALLATION

min. 1 1⁄8" (28 mm)
CORNER INSTALLATION WITH TWO PRODUCTS
min. 4" (102 mm)
min. 4" (102 mm)
Allow min. 1 1⁄8" (28mm)
clearance from the cutout to a
corner
Allow min. 4" (102 mm) clearance
from the cutout to a corner
Refer to Pantry installation for corner installations with a
pantry unit or beverage unit with bottle holder.
TDS1-20 ONLY
16 ½"
(420 mm)
TDD1-20, TDT1-20 & TB1-20 ONLY
16 ½"
(420 mm)
Provide a support behind
the chassis to screw into
20 ½"
(520 mm)
1 ¼"
(31 mm)
measured from
back of frame
Provide a support above the
chassis to screw up into
20 ½"
(520 mm)
min. 7⁄16"
(11 mm)
1 ¼"
min. 13⁄16"
(31 mm)
(30 mm)
measured from
back of frame
9