Tauris CMW-297 Manual

CMW - 297
Professional Installer Highly Recommended - The bracket manufacturer will not warrant any faulty installations, and damage to panels or any other fixtures / fittings as a result of incorrect installation.
STEP 1
Attach bracket to the wall.
IMPORTANT: PRE-DRILL HOLES
Make sure bracket is secured to stud,
or anchors are used for brick or concrete.
1
5
9
9
5
STEP 3
Attach railings to back of the TV.
(M5, M6, M8)
(M5, M6, M8)
STEP 4
Hook TV onto face plate
Once the railings (3) are firmly
attached to the TV, hook
the railings onto the face
plate (2) and secure
into place using
locking screws
provided.
w w w . t a u r i s . c o m . a u
DISTRIBUTED BY RVM AUSTRALIA t: (08) 9417 9944 e: sales@rvm.com.au
Find stud and select position
for bracket (1) on the wall.
Level bracket and mark
holes with a pencil then drill
6
pilot holes.
Using a socket wrench fix
arm bracket to the wall
with hex head screws
(5) and washers (9).
If fixing to brick or
concrete use plastic
anchors (7).
Cover screw with
plastic cap (6).
6
Locate screw fixtures in
the back of your TV
and attach railings (3)
using the screws
provided.
The screw size required
will vary on each TV so
we have provided you
with a range to choose
3
from (M5, M6, M8).
Optional:
Insert spacers (8) or
additional washers (9) if
back of TV is not a flat.
2
3
3
STEP 2
Attach face plate to bracket.
1
13
11
12
STEP 5
Adjusting tilt and roll.
You can easily adjust
the tilt and roll of the TV
by simply loosening the
bolts in the centre of
the face plate with the
allen key provided (14).
Secure bolts tightly for
a fixed position or leave
slightly loosened for an
adjustable platform.
Note: Make sure all screws are firmly tightened after adjusting tilt and roll.
Attach face plate (2) to
arm bracket using the
allen key (13), bolt (4)
and black washers (10).
Securely tighten nut (4)
4
using the wrench
provided (12).
Clip cable saddle (11)
onto base of arm.
10
10
10
4
2
10
ADJUST TILT HERE
ADJUST ROLL HERE
Mar 2012