Table 5: Tightening Torque For Turbocharger Fixing Screws - ABB TPS48-H33 Operation Manual

Operation Manual / 4 Product description / TPS44-H.. - TPS52-H..
2 Removing and Installing
2.3.3 Placing the turbocharger on the bracket and aligning
Figure 9: Placing the turbocharger on the bracket
1. Make sure that covers of the oil and water connections are removed.
2. Make sure that the gaskets are not damaged and are positioned correctly in the slots.
3. Install the swivel lifting eye (S) and attach the lifting gear to it.
4. Align the turbocharger over the threaded rods of the bracket.
5. Place the turbocharger on the bracket.
6. Lightly oil the hexagon nuts.
7. Fit the hexagon nuts and tighten in accordance with the following section.
8. Connect cable to speed sensor (86505).
2.3.4 Fastening the turbocharger with a standard nut
Tighten the fitted nuts in accordance with the following table.

Product Through hole in
bearing casing [mm]
TPS44
TPS48
TPS52

Table 5: Tightening torque for turbocharger fixing screws

Remove the lifting gear.

© Copyright 2016 ABB. All rights reserved.
Ø 17
Ø 17
Ø 20
HZTL4037_EN
Fixing screws [mm]
M16
M16
M20
Page 16 / 99
Tightening torque [Nm]
(assumed friction coefficient
µ = 0.12)
280
280
560
Revision A August 2016