Related Manuals for Aeta Audio Systems ScoopFone HD
Summary of Contents for Aeta Audio Systems ScoopFone HD
-
Page 1: Getting Started
Getting started www.aeta-audio.com 55 000 075-E © 2017 Specifications are subject to change without notice... -
Page 2: Front Panel & Controls
Front panel & controls 11 13 14 15 16 17 18 19 20 Level control: This potentiometer OLED Screen controls the microphone level. Navigation keys: Use the key to Mute indicator: The LED turns red access the configuration menu. Use the when the microphone input is enabled. - Page 3 Microphone gain: When is enabled, 16. Communication indicator: use key to increase and key The LED turns green when the decrease gain of the microphone. communication is established. Network auto: When is enabled, use 17. Call key: Use the Green phone key to this key to select the automatic initiate a call.
- Page 4 OLED Screen INTRODUCTION We advise you to read this quick guide to start using the ScoopFone in a very short time. more detailed information on each step, do not hesitate to consult the full user manual on our web site: www.aeta-audio.com The easy-to-use ScoopFone is designed Network level indicator: 5 levels.
- Page 5 External power supply SETTING IT UP You can use an external power DC. ScoopFone needs 12V DC but is able to Powering work with voltage from 10 to 16V / 1A Before switching on the ScoopFone, you minimum. need to have 6 AA batteries inserted in The external DC supply is also used to the bottom compartment, or an external charge...
-
Page 6: Set A Call
SIM card SET A CALL To establish communication, you should have a SIM card from a telecom Switching ScoopFone on /off operator. ScoopFone supports standard SIM size, use a card adaptor to support To switch ScoopFone on, press micro SIM Card (Contact your dealer for seconds. - Page 7 Set a call Set a call with a memory Press key and enter the number of Enter directly your phone number with requested memory from 1 to 9. the digital keypad. The number appears and you can Press the key twice to have the establish the communication with the international symbol.
-
Page 8: Adjust Your Microphone Level
mode and press the key to increase or the key to decrease the gain of the Redial microphone until you get the right level. Press the key to access to history Hang up call list. Select the number and press again. -
Page 9: Line Input Adjustment
Line input adjustment Voice. In this case, the 3G LED is a useful indication that HD Voice is possible. In addition, it is possible to force operator The line input is mixed with the on 3G mode: enable mode and press microphone input. -
Page 10: How To Improve Network Reception
How to improve network reception The file must have the following format: You can connect a second antenna on Memory number: phone number the AUX antenna connector and enable it by menu. 1:0141361268 WHEN YOU REMOVE THE AUX 2:0141361279 ANTENNA DON’T FORGET TO DISABLE THIS FEATURE BY MENU Note: All memories will be set or erased Import... - Page 11 MENU Line output level adjustment You can select maximum output level from -9dBu to +21dBu Microphone phantom power You can enable 48Volts phantom power Microphone button You have 3 functions available : Flip-flop : change the microphone input state between enabled and disabled Push to talk : The key should be keep pressed to enable the microphone input Cough key : The key should be keep pressed to...
- Page 12 Echo cancel You can enable a local echo cancellation Noise Gate configuration You can enable noise suppression on the mixed signal Audio Balance between Send and Receive Available settings: Rx only, Rx +1/3Tx, Rx+Tx Rx = Reception from the network Tx = Transmission to the network Auxiliary antenna Should be set to “connected”...
- Page 13 PIN save If a wrong pin is enter, PIN save option will switch to off. The PIN is saving only if it is correct. Enable DTMF Capability to send DTMF tones during an active call through digital keypad. Automatic or Manual answer You can specify the number of RINGs before automatically answering or set it to manual answer.
- Page 14 Rear side panel Line OUT: 3 pins XLR balanced Line In: balanced analog DC Power: 2.1mm jack for output. Level adjustment via Menu input with line level on external additional DC Max output : +21dBu 6.35mm jack. power 10 -16 V. Can also be used for connecting an AC/DC adaptor Aux Antenna: SMA...
-
Page 15: Left Side Panel
Left side panel Main Antenna: SMA connector to connect the antenna Right side panel Headphone: Stereo 6.35mm Jack Mic/Line IN: balanced Compatible with headphone ≥16 Ω. analog adjustable gain from 0 to 48 dB by16dB steps. Max acceptable level: +19 dBu, +48V powering available. - Page 16 www.aeta-audio.com...
Need help?
Do you have a question about the ScoopFone HD and is the answer not in the manual?
Questions and answers