Sharp 27SC260 Operation Manual page 7

Antenna Connections (Continued)
NOTICE
F-type connector
75-ohm coaxial cable
CABLE TV (CATV) CONNECTION
• A 75 ohm coaxial cable connector is built into the set for easy hookup. When connecting the 75 ohm
coaxial cable to the set, screw the 75 ohm cable to the COAXIAL CABLE CONNECTOR.
• Some cable TV companies offer "premium pay channels". Since the signals of these premium pay
channels are scrambled, a cable TV converter/descrambler is generally provided to the subscriber by
the cable TV company. This converter/descrambler is necessary for normal viewing of the scrambled
channels. (Set your TV on channel 3 or 4. Typically one of these channels is used. If this is unknown,
consult your cable TV company.) For more specific instructions on installing cable TV, consult your
cable TV company. One possible method of utilizing the converter/descrambler provided by your
cable TV company is explained below.
Please note: RF switch equipped with position A/B (not provided) is required.
"A" position on the RF switch (not supplied) : You can view all unscrambled channels using the
TV's
"B" position on the RF switch (not supplied) : You can view the scrambled channels via the converter/
RF switch (not supplied)
OUT
Note:
• Consult your SHARP Dealer or Service Center for the type of splitter, RF switch or combiner that
might be required.
F-type connector should be finger-tightened only.
When connecting the RF cable to the TV set, do not
tighten F-type connector with tools.
If tools are used, it may cause damage to your TV
set.
(The breaking of internal circuit, etc.)
A
IN
B
OUT
Cable TV converter/
descrambler
(not supplied)
channel keys.
descrambler using the converter's channel keys.
Two-set
signal
splitter
(not
IN
supplied)
Cable TV Line
Dimension: 140mm x 215mm
7