FreezyBoy One White User Manual page 47

42
6. Clip the cable clamp onto the cable, 80 cm
down from the appliance (measure this
distance).
7. Screw the cable clamp (with cable) onto the
right inside wall of the base unit. Ideally, the
clamp should be 35 cm above the bottom of
the pull-out and 42 cm back from the outside
edge of the base unit.
If using raiser: Place FreezyBoy
8.a)
Make sure that all four of the rubber feet are
positioned securely in the round holes on the
raiser.
If not using raiser: Place FreezyBoy
b)
mounting plate.
Make sure that the front two rubber feet are
positioned securely in the round holes on the
mounting plate.
9. Connect FreezyBoy
If using FreezyBoy
10.
Place the waste bin in the pull-out beside
FreezyBoy ® . Screw the support brackets
to the base of the pull-out, positioning one
bracket in front of the waste bin and the
other behind it.
® on the raiser.
on the
®
to the power supply.
®
with a waste bin:
®
47