Sharp 20F640 XFlat Operation Manual page 41

Operation of Remote Control (Continued)
L HOW TO IDENTIFY A VCR
The remote control may already be set to
operate your VCR. Try this initial check before
going on to the following "identify" section.
(1) Press TV/VCR button.
(2) Point remote towards VCR and press POWER
(DVD/VCR) .
(3) Does the remote turn the VCR ON and OFF?
• If yes, the remote is ready to operate the VCR
and no further steps are needed.
• If no, continue to the "identify" section.
L To Identify Your VCR – Direct Entry Method.
Use the following steps and list to quickly find
the remote control code for your accessory
VCR.
• First look up your VCR's remote control code
number before going through the direct code
entry steps control.
• If this procedure does not identify your
accessory VCR, use the Search method of
identification (described in the next section).
(1) Press TV/VCR button.
(2) Press and hold down DISPLAY and
on your remote control.
Then release both buttons.
(3) Within ten seconds after releasing DISPLAY
and , enter your VCR's two-digit
CH s
remote control code number using the
REMOTE KEYPAD (refer to list).
• The remote control is now ready to send
commands to your VCR.
TV POWER
REMOTE
KEYPAD
POWER
(DVD/VCR)
CH s
POWER CATV TV
DVD VCR
DISPLAY INPUT
1 2 3
4 5 6
7 8 9
FLASHBACK ENTER
0 100
PERSONAL PREFERENCE
A B C D
CH
8
VOL VOL
; :
+
–
9
CH
MENU MUTE g SKIP f
9 VCR-CH 8
POWER (DVD/VCR)
PLAY
:
REC
REW FWD
L STOP
( )
PAUSE
J
TV • CATV • VCR • DVD
Some brands have more than one remote code
listed, due to changes in the remote codes from
early to later model years, or due to format
differences (VHS/BETA). In such cases, you
may have to try more than one code to find the
code your VCR accepts.
Note:
Depending on the model, year produced, brand,
and type of VCR, some models may not be
compatible with the remote control.
L To Identify Your VCR – Search Method.
(1) Press TV/VCR button.
(2) Press POWER on the VCR to ON.
(3) Stand at least six feet away from the front of
the VCR.
Point the remote towards the VCR.
Hold down DISPLAY and
same time. KEEP HOLDING THE BUTTONS
DOWN.
(4) Watch the Channel Number indicator on the
VCR, Channel numbers will scan up when the
VCR has been identified.
Release DISPLAY and
the channel numbers start to scan up.
The VCR's remote control code number has
been identified, and the remote is ready to
operate the VCR.
CATV/DVD-TV/VCR
DISPLAY
CHANNEL UP (,)/
DOWN(9)
CH a
CH a
as soon as
at the
41