Sargon XTG300 series Installation Manual

Always there for yoU!TM
800-9-SARGON
Sa gonTM
8954 Lurline Ave, ., Chatsworth, CA 91311 ., USA
The M
I
sure 01 Quality
818882-6904" Fax: 818 718-8206
I
-r. t
I
XTG300
series installs,
'iQfJ'
guiI!Je '
I
I
if~
I
v10/14/98-LD
I. INTRODUCTION
Apparently most installers only read the installation instructions when they run into trouble.
For this reason the most important points-the ones most likely to result in damage-have
been put in section II. READ THIS BEFORE STARTING.
Installers are strongly advised to read section II before attempting to install miniscales.
It
is important to
properly install the miniscales,
as
described In this manual. Failure to do so may result in
severe damaqe to the miniscales. WARRANTY IDOES NOT
COVER FAULTY INSTALLATION!
CAUTION
If the system was mounted by the supplier before being shipped and it does not work upon
arrival:
1. Check for any damage which may have occurred during shipment.
2. Contact the freight company as soon as possible to report any potential damage.
miniscale components
1. Spar.
2. Encoder box which travels along the spar.
3. Cable for power to miniscale and output from miniscale.
4. Connector to digital readout.
5. Endcaps
5
1
5
i.;
@(§3""'oo :Jlli)
""""'~
In US'-­
~
r
-r-=
==H==
2
3
I
L...
4
figlue
1. rniniscale
components