All Seasons Hire Cyclone 50 Operating Instructions

Advertisement

At Allseasons Hire we take your health and safety very seriously. Please read
these operating instructions carefully before attempting to use the equipment.
If you have any concerns or queries please call us for advice FREE on 0800-
0828001
Failure to follow these instructions could damage this equipment.
Please ensure you have read and understood these instructions fully
BEFORE attempting to operate the equipment

Important information

o
DO NOT FLASH TEST ABOVE 1250V. PERMANENT DAMAGE WILL OCCUR
o
ALWAYS START THE FAN ON THE HIGHEST SPEED SETTING.
If problems are experienced, call us FREE on 0800-0828001 Maintenance
should only be attempted by competent personnel in accordance with the
Cyclone 50 2011
Allseasons Hire
©
Cyclone 50
IMPORTANT!

OPERATING INSTRUCTIONS

instructions or supplier guidelines.
Page 1 of 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Cyclone 50 and is the answer not in the manual?

Questions and answers

Summary of Contents for All Seasons Hire Cyclone 50

  • Page 1: Operating Instructions

    ALWAYS START THE FAN ON THE HIGHEST SPEED SETTING. If problems are experienced, call us FREE on 0800-0828001 Maintenance should only be attempted by competent personnel in accordance with the instructions or supplier guidelines. Cyclone 50 2011 Page 1 of 3 Allseasons Hire ©...
  • Page 2 Blow out the grills with compressed air if ‘clogged’ up Never move the unit whilst it is operating! Switch the unit OFF and unplug from its power supply, wrap the cable round the storage ears. Cyclone 50 2011 Page 2 of 3 Allseasons Hire ©...
  • Page 3 POOR AIRFLOW SPEED CONTROL ON TURN SPEED LOW SETTING CONTROL KNOB CLOCKWISE TO INCREASE AIRFLOW GRILLS DIRTY BLOW COMPRESSED AIR THROUGH GRILLS TO CLEAN AIR INLET GRILLS REMOVE OBSTRUCTED OBSTRUCTION Cyclone 50 2011 Page 3 of 3 Allseasons Hire ©...

Table of Contents