Injectidry Systems IRP-400 Operating Instructions

BEFORE GETTING STARTED

This manual is specifically for Infrared Heating Panels developed to
target difficult to dry dense materials such as concrete flooring,
Gypcrete flooring, ceramic tile floors with mortar base, backerboards
and the like. When used for this purpose, they should be set up with
the hot black side of the panels facing down. Always use the accom-
panying legs for proper spacing. The panels can also be used to heat
and dry dense walls including plaster, multiple layers of drywall and
insulation board. When used in this fashion, the legs should be used
to space the panels vertically on their side.

SAFETY WARNINGS

Safety is always the number one concern when using electrical
equipment. All electrical equipment can be dangerous if misused,
abused or damaged. If the user fails to observe the warnings, injury
might result to person, or property. By following the warnings below,
the user can reduce the risk of shock, personal injury or fire.
DO NOT operate near combustible materials such
as paper, cardboard, furniture, drapes etc. Treat
with caution as you would any space or portable
heater.
DO NOT use unless you have read the operating
instructions.
DO NOT use outside, in water, in rain or standing
water.
DO NOT remove the cover/housing as serious
shock might occur.
DO NOT remove or alter grounding plug.
DO NOT connect to an ungrounded outlet.
DO NOT service the unit while connected to any
power source.
DO NOT alter or operate IRP with a damaged
cord or plug. Discard or return to an authorized
service facility for examination and/or repair.
DO NOT run cord under carpeting. DO NOT cov-
er with throw rugs, runners, or similar coverings.
DO NOT route cord under furniture.
18-02-IRP400-OI
READ & SAVE THESE INSTRUCTIONS
Injectidry Systems Inc - PO Box 446 Marysville WA 98270-9998 - 800.257.0797 - Fax 425.745.8480

Operating Instructions

Infrared Heating Panel
IRP-400

DO NOT place on unstable or wet surface or in an en-
closed space where there are no air exchanges.
DO NOT operate any device with a damaged cord or
plug.
Not intended for use on sensitive materials such as
hardwood flooring, wood trim or wood cabinetry as the
wood can dry too rapidly causing permanent damage.
DO NOT operate in areas where children or pets have
access.
DO NOT operate in environments where the ambient
temperature might be over 90 ֯ F as the unit might
become too hot to touch.
To move IRP-400, unplug and let it cool down prior to
moving. Grasp each panel end frame where it will be
cooler to the touch.
TRAINING VIDEOS & WEBINAR TRAINING
Training videos on wall injection and how to dry hardwood floors are
located on our website https://www.injectidry.com/videos/. After
watching all the videos you may schedule a training webinar (call for
information).
UNPACKING YOUR PRODUCT
Great care has gone into the protection of your unit. We recommend
keeping the packaging in case a return is required.
In the upper left corner of each box is a packaging label which speci-
fies the model number for the kit designation and the contents and
qty for each.