Do you have a question about the HLS-100 and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Wessex HLS-100
Page 1
Assembly Guide Wessex Country Log Splitter HLS-100 Hydraulically Powered, Tractor Mounted REV A 17/11/15...
Page 2
Tools Required Spanner / Socket – 17mm, 19mm, 24mm (2 of Each) Screwdriver – Flat Head or Philips Arc x2 Front Leg x2 Rear Leg x2 Large Adjustable Spanner Frame Upper x2 Clamp Plate Log Pusher Valve Block Mount Front Brace Rear Brace Main Spine Assembly Control Leaver x2...
Page 3
M12 X 130 M12 X 100 M12 X 100 Full Nut Nyloc Nut Nyloc Nut Attach the LHS Upper using the bolts labelled above (Note: One bolt is longer than the others and requires a full nut) Make sure that the 2 Upper Pieces are not over lapping. (Edges must meet before tightening bolts) Fully tighten all top M12 Bolts 2x M10 X 35 2x Nyloc Nut...
Page 4
4x M10 X 35 2x M10 X 35 Connect the two Side Braces to the rear frame. Use 8x M10 X 35 bolts with washers and nyloc nuts. Do Not Fully Tighten Repeat for opposite side. 2x M12 X 35 Connect the green front legs with 2x M12 X 30 Bolts each side with washers and nyloc nuts.
Page 5
4x M12 X 90 4x Nyloc Nut Connect the front Upper Brace / Cover Pivot using 4x M12 X 90 Bolts with washers both sides and a nyloc nut. Do Not Fully Tighten. 4x M16 X 130 Washers + Nyloc 4x M20 X 130 Washers + Nyloc Connect the Pusher Head to the end of the Hydraulic Ram using the M16x130 Bolt and Nyloc –...
Page 6
2x Nyloc Nut Connect the valve block to the underside of the box section using two M12 nyloc nuts. The full nuts from steps 1 and 2 are used as spacers and must not be removed. Fully Tighten 4x M12 Washer Place the Handles through the slots in the Upper Frame and secure them with the M12 X 120 Bolt.
Page 7
2x M10 X 100 Attach the Clamp Plate to the underside of the Log Pusher Assembly Using 2x M10 X 100 Bolts with Nyloc Nuts and Washers – Fully Tighten 2x M12 X 30 Attach the front brace and secure with 2x M12 X 30 Bolts with Nyloc Nuts and Washers - Fully Tighten REV A...
Page 8
2x WX-2026 Attach the Rear Brace with the Bolt in Lower Link Pins that are provided. Use a Screw Driver in the hole on the end of the pin to stop the pin turning whilst tightening. Use a Large adjustable spanner to fully tighten the nut. 2x M10 X 20 Connect the Cover / Log Shute with the M10 x 20 Bolts.
Need help?
Do you have a question about the HLS-100 and is the answer not in the manual?
Questions and answers