Table of Contents
Advertisement
maintenanCe and
serViCing
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
From aCCidentaL
oPeration:
turn the Power switch of the
tool off and remove the
Battery Pack before
performing any inspection,
maintenance, or cleaning
procedures.
to PreVent serious
injurY From tooL
FaiLure:
do not use damaged
equipment. if abnormal noise
or vibration occurs, have the
problem corrected before
further use.
Cleaning, maintenance, and
Lubrication
1.
BeFore eaCh use,
general condition of the tool. Check
for loose hardware, misalignment or
binding of moving parts, cracked or
broken parts, and any other condition
that may affect its safe operation.
aFter use,
2.
of the tool with a clean cloth.
3.
Periodically lubricate the contact area
between the Reciprocating Lever (14)
and the ball section of the Moving
Blade (6) with white lithium grease.
To access the junction, squeeze the
Page 8
For technical questions, please call 1-800-444-3353.
to PreVent
serious injurY
inspect the
wipe external surfaces
Release Tabs (2/9) on either side of
the housing near the Blades (see
Figure 1) and pull the Cutter Head off
of the tool.
4.
When the Blades become dull or
damaged they can be replaced.
To replace the Blades, remove
the Cutter Head from the tool as
described in step 3 above. Replace
with a new Cutter Head Assembly.
5.
warning! do not use if either
the Battery Pack or Charger are
damaged in any way.
BATTERY MUST BE RECYCLED OR
DISPOSED OF PROPERLY. Do not
short, incinerate or open battery.
SKU 67434
Advertisement
Table of Contents
