Miltronics 1000 Instruction Manual

Read entire manual prior to installation and operation.
CAUTION: Changes or modifications not expressly approved by Miltronics could void the user's authority to operate this device.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for an intentional radiator pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the
instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician for help
As an option, additional receivers and sensors may be used in conjunction with your driveway system.
This will allow you to place them in various locations for your convenience.

INFRA RED SENSOR/TRANSMITTER OPERATION:

The infrared detector is positioned behind the round lens. It has a horizontal detection angle of 40 degrees. The effective
detection range of the sensor is from 0 feet to 40 feet. The infrared sensor detects vehicles, intruders, guests etc., by sensing
their heat and motion. When someone or something moves through the detection zone, the sensor detects the intrusion and
transmits a signal to the receiver.

INFRA RED SENSOR/TRANSMITTER INSTALLATION:

First, install a high quality, 9-volt, alkaline battery in the compartment located in back of the sensor. Securely close the battery
cover. Mount the sensor approximately 2-3 feet above the ground to a tree, wooden post or side of a building. A metal bracket
is provided. The lens must have an unobstructed view of the coverage area. Extend the flexible wire antenna upward. Some
objects may not be detected if the sensor is placed too high or too low. Adjusting may be required prior to calling for
technical support. Keep the sensor as close to the edge of the driveway as possible. The sensor should be strategically
located so that it detects objects moving across detection zone. Do not mount the sensor facing the sun, bodies of water or any
reflections. This causes variations in the temperature pattern "seen" by the sensor and may cause false alarms or damage the
lens.
Alert System Model 1000
Receiver and Sensor/Transmitter
INSTRUCTION MANUAL
MILTRONICS Manufacturing, Inc.
Keene, NH 03431
95 Krif Road
1-603-352-3333