Advertisement
Quick Links
Advertisement
Related Manuals for WamBlee W440
Summary of Contents for WamBlee W440
- Page 1 Instruction manual W440 AIS Sart Sniffer Ed. 1.4.0 (EN) 5/2015...
- Page 2 Doc: W440_1_4_0_EN...
- Page 3 Picture 1: Frontal view...
- Page 4 Picture 2: Schematic diagram...
- Page 5 Illegal disposal of the product by the user implies the application of administrative sanctions provided by law. WamBlee is a registered trademarks of WamBlee s.r.l...
- Page 6 Introduction Congratulations and thank you for purchasing the W440 AIS SART Sniffer, one of the most high-tech, reliable devices available on the market. As the owner of this radio device you are advised to: Read this manual. • Adopt a schedule check planing.
-
Page 7: Technical Specifications
Technical specifications Power supply From 9 to 30 Volts DC Consumption < 0.1 A typical Working temperature From -20°C a +55°C Storage temperature From -30°C a +70°C Relative Humidity < 70% Interface NMEA 0183, galvanic isolation Impedance > 800 Ohms Speed 38400 baud AIS Sentence... -
Page 8: Installation
Installation The W440 AIS Sart Sniffer can be installed on DIN guide (standard model) or on wall using an adapter kit (on request). Please note that the W440 is not a waterproof device, and shall be installed on a protected area. - Page 9 (pin 6 and 7 of the lower connector). This port is capable of accepting a signal according to the standard NMEA 0183 at 38400 baud. On the front of the W440 are two indicator lights (LEDs 2, 3) Here below is the table of their functionality.
- Page 10 Position (C) = selection mode and reset (with spring return to • position B). The W440 unit is also equipped with two DIP switches located to the left of the lower connector (4). Their function is the following: DIP Switch...
- Page 11 How to store the MSLD MOB ID The W440 AIS Sart Sniffer lets you store up to 8 AIS SART codes, so that the alarm is activated only for codes stored (unless this feature is disabled, see the dip switch setting).
- Page 12 How to 'arm' your W440 To ensure that your W440 is ready to receive any alarm you must proceed as follows: Move the knob switch to position B. A beep of 1 second and the green LED will indicate the correct power on sequence.
- Page 13 W440 unit. Turning off the alarm and reset To turn off your device W440 or reset an alarm received, simply move the switch in position A. Please note that The programmable ID codes stored in the table remain in memory even turning off the device.
-
Page 14: Periodic Checks
It is advisable to check with a certain periodicity (at least once a month) your W440 system, the control can be done using the devices on board AIS MOB TEST mode and check their recognition as described in paragraph "a result of activation MOB alarm message. - Page 15 Note...
- Page 16 Wamblee s.r.l. Via Vittori 19 – 48018 FAENZA (RA) ITALY Tel. +39 0546 623891 / Fax +39 0546 623891 / email:info@wamblee.it Made in Italy...
Need help?
Do you have a question about the W440 and is the answer not in the manual?
Questions and answers