All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded operator who recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this implement to be used with all its safety equipment properly attached to minimize the chance of accidents.
Page 12
Dipperstick & Bucket Operation OPERATION Left Side Stabilizer Position OPERATION Right Side Stabilizer Position OPERATION Boom Lock OPERATION Swing Lock NAME Model 95HD -------------- Universal One Call LOGO Rhino STRIPE White, 13" WARNING To Prevent Bodily Injury Safety Section 1-9...
FEDERAL LAWS AND REGULATIONS This section is intended to explain in broad terms the concept and effect of federal laws and regulations concerning employer and employee equipment operators. This section is not intended as a legal interpretation of the law and should not be considered as such. Sec.
INTRODUCTION NOTE: This safety alert symbol identifies important safety messages in this manual. Observe and follow all safety messages to prevent personal injury. If at any time you have a service problem with your backhoe or need new parts, contact your local dealer. Your dealer will need your backhoe model number and serial number to give you prompt efficient service.
WARNING: Do not modify or alter this implement. Do not permit anyone to modify or alter this Implement, any of its components or any Implement function. Drawbar may need to be removed if it interferes with reservoir. If drawbar can be left in place, retaining bracket (4) should be installed on left side of pump as shown and positioned on left side of tractor drawbar.
Page 36
1A: ROD END BOOM CYLINDER 1B: BASE END BOOM CYLINDER 2A: ROD END RIGHT SWING CYLINDER 2B: ROD END LEFT SWING CYLINDER 3A: ROD END LEFT STABILIZER CYLINDER 3B: BASE END LEFT STABILIZER CYLINDER 4A: ROD END RIGHT STABILIZER CYLINDER 4B: BASE END RIGHT STABILIZER CYLINDER 5A: BASE END BUCKET CYLINDER 5B: ROD END BUCKET CYLINDER...
MAINTENANCE GENERAL TORQUE SPECIFICATIONS USE THE FOLLOWING TORQUES WHEN SPECIAL TORQUES ARE NOT GIVEN Torque Specifications for Torque Specifications for 37º JIC Fittings SAE O-Ring Fittings F3788-7-04 Maintenance Section 5-10...
Page 41
TO THE OWNER/OPERATOR/DEALER To keep your implement running efficiently and safely, read your manual thoroughly and follow these directions and the Safety Messages in this Manual. The Table of Contents clearly identifies each section where you can easily find the information you need.
Need help?
Do you have a question about the 95HD and is the answer not in the manual?
Questions and answers