Do you have a question about the Synergy and is the answer not in the manual?
Questions and answers
Summary of Contents for Yardney Synergy
Page 1
Installation and Operation INSMAN-114 Synergy Quick Start Guide Phone: 951.656.6716 | Toll-Free: 800.854.4788 | www.yardneyfilters.com Yardney Water Management Systems, Inc. | 6666 Box Springs Blvd. | Riverside, CA 92507...
Page 2
Synergy Quick Start Guide Ver: 20150709 Intro This guide will help a Synergy user get started as quickly as possible. For an in-depth look at how the Synergy Controller works, please see the Synergy User’s Manual. Electrical Connections and Buttons Once the Synergy Controller is mounted and the wires are routed to the enclosure, connect the wires as they are labeled in Error! Reference source not found..
Page 3
Error! Reference source not found. and Error! Reference source not found. show the full menu map of the Synergy Controller, including sub menus of the top menus. A user can navigate the menus by rotating the center button (SELECT or MODIFY) and enter sub menus by pressing the center button.
Page 4
Synergy Quick Start Guide Ver: 20150709 Figure 3: Main Menus Page 4 of 8...
Page 5
Synergy Quick Start Guide Ver: 20150709 Figure 4: System Configuration Menu Page 5 of 8...
Page 6
Synergy Quick Start Guide Ver: 20150709 Generic Setup This section describes each of the most critical settings for basic operation as well as the default value for each of those settings. If a user wishes to change any of the defaults, they may follow the instructions in the appropriate sub-section.
Page 7
Synergy Quick Start Guide Ver: 20150709 will change which of the main menus are displayed. Menus A6 through A9 will be accessible when periodic flush timing is selected, while menus A10 and A11 are used for scheduled flush timing. Master Valve Offset Default Value: Disabled Navigate to menu B5 to view the Master Offset menu.
Page 8
Synergy Quick Start Guide Ver: 20150709 Backwash Schedule The menus displayed for the backwash schedule depend on the option selected in menu B4, as discussed in the Flush Timing section. Given that this default value is periodic, the default scheduling values are as follows;...
Need help?
Do you have a question about the Synergy and is the answer not in the manual?
Questions and answers