Page 1
MTV-1-CP 230 VAC POTENTIOMETER WITH MIN & MAX SETTINGS, DRY CONTACT Mounting and operating instructions...
Page 2
TECHNICAL DATA STANDARDS OPERATIONAL DIAGRAM WIRING AND CONNECTIONS MOUNTING INSTRUCTIONS IN STEPS VERIFICATION OF INSTALLATION INSTRUCTIONS TRANSPORT AND STORAGE WARRANTY AND RESTRICTIONS MAINTENANCE MIW-MTV-1-CP-EN-000 - 22 / 08 / 2018 2 - 8 www.sentera.eu back to the table of contents...
Page 3
In case there are any questions that are not answered, please contact your technical support or consult a professional. MIW-MTV-1-CP-EN-000 - 22 / 08 / 2018 3 - 8 www.sentera.eu...
Remove the knob by turning it to the right until it pops out. Unscrew the nut to remove the cover of the external enclosure. Do the wiring according to the wiring diagram (see Fig. 1 Wiring and connections). MIW-MTV-1-CP-EN-000 - 22 / 08 / 2018 5 - 8 www.sentera.eu...
Page 6
Mount back the cover and secure it with the nut. Put back the knob and turn it to off position. Turn on the power supply. MIW-MTV-1-CP-EN-000 - 22 / 08 / 2018 6 - 8 www.sentera.eu back to the table of contents...
Page 7
In case of faulty operation, please check if: ► the right voltage is applied; ► all connections are correct; the regulated device is functioning. ► MIW-MTV-1-CP-EN-000 - 22 / 08 / 2018 7 - 8 www.sentera.eu back to the table of contents...
Page 8
In case of heavy pollution, clean with a non-aggressive product. In these circumstances the unit should be disconnected from the supply. Pay attention that no fluids enter the unit. Only reconnect it to the supply when it is completely dry. MIW-MTV-1-CP-EN-000 - 22 / 08 / 2018 8 - 8 www.sentera.eu...
Need help?
Do you have a question about the MTV-1-CP and is the answer not in the manual?
Questions and answers