Features And Descriptions - Champion WheelyBird Instruction Manual

IV. Features and Descriptions
Receiver Unit
A) Remote Learn Button
• Press the Remote Learn Button to allow the
receiver to be paired with the wireless remote
transmitter. (The remote learn light will turn red
for 10 seconds).
B) Remote Learn Light
• Remote learn light will turn red to indicate
that the receiver is ready to learn the remote
transmitter.
• Once it receives the transmitter signal it will flash
red three times so you know it received the signal.
• You have 10 seconds to transmit the signal before
you have to repeat the learn sequence.
C) Receiver Status
• When Receiver Status LED is Green the receiver
is powered on and will accept a signal from the
remote.
• As soon as a signal is received the status light will
turn red until the trap fires.
• Once trap fires the light will turn back to green.
D) Removable Antenna
• Antenna must be attached for proper operation.
E) Throw Delay
• Adjust for how long of a delay there will be on the
trap from the time the receiver receives a signal
from the remote.
• This time is set from 15 Seconds to 0 seconds.
F) 12V Power Connector and Output Connector
• Allows user to quickly and easily attach receiver to
the trap.
Pushbutton Remote Transmitter
A) Transmitter Button (Throw Button)
• Pressing this button will transmit the command
to activate the output to any receiver which has
learned the transmitter.
• Button must be released before transmitting another command (holding down the button only sends a single
command).
B) Signal Light
• Illuminates when signal is being transmitted.
C) Transmitter Removable Antenna
• Antenna must be attached for proper operation.
D) Battery Compartment Cover
• Remove to install/replace the A23 Battery.
40923_WirelessRemote_WheelybirdWorkhorse_2LIMv2.indd 5
A B
C
4
D
F
D
E
B A C
9/26/17 11:29 AM