Advertisement
SF804-0
Smoke Detector
Installation Instructions
General Introduction
The SF804-0 Smoke Detector is designed to sense smoke that comes into the
detector's chamber. It does not sense gas, heat, or flame. When it detects a
certain density of smoke the horn will sound and the RF module will emit signals
to the Gateway. Its great compatibility with our U-Net family security products
makes it suitable for smart home cloud based platforms such as Homesys.
Product Layout
The sensor consists of two parts; a sensor module and a transmitter module The
transmitter module can be detached by twisting it clockwise against the sensor
module.
Sensor Module : Front and Back view
Sensor module
Transmitter module
Binding with Homesys
1. Twist the transmitter module clockwise to detach it from the sensor module
2. Disconnect the connector from the connector pins of the sensor module.
5
3. Open the battery cover.
4
6
1
Transmitter module: Front and Back view
Horn
Test Button
Smoke LED
Connector pins
Cover Latch
Battery Cover
Take note of the connector direction as you will need to connect it back later.
Tamper switch
Connector
Learning key
○
Link LED
10
⑪ Mounting bracket
Skirt Panel
Advertisement
Table of Contents
Related Manuals for EVERSPRING SF804-0
Summary of Contents for EVERSPRING SF804-0
-
Page 1: Installation Instructions
Installation Instructions General Introduction The SF804-0 Smoke Detector is designed to sense smoke that comes into the detector’s chamber. It does not sense gas, heat, or flame. When it detects a certain density of smoke the horn will sound and the RF module will emit signals to the Gateway. -
Page 2: Manual Binding
Learning key for 3 seconds then release, and the Link LED ○ will start to flash. This implies SF804-0 has now entered binding mode. 3. Within 5 seconds, the Link LED will stop flashing and then turn off, indicating... -
Page 3: Tamper Protection
Tamper Protection detector will sound (alarms are listed in “Events”). Note: It is necessary that the Homesys gateway is powered and connected Tamper switch is set inside the housing of SF804-0 to prevent it from being to internet. forcibly removed. -
Page 4: Troubleshooting
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and To reset SF804-0 back to factory default state: 1. Insert the batteries into the unit on, the user is encouraged to try to correct the interference by one of the 2. - Page 5 2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. www.everspring.com 3F., No. 50, Sec 1, Zhonghua Rd., Tucheng Dist., New Taipei City 23666, R.O.C...
Need help?
Do you have a question about the SF804-0 and is the answer not in the manual?
Questions and answers