Page 3
Please allow two hours of charge prior to first use. ➋ CONNECT ORBITER TO CHARGER 1. Connect the charger to the power connector on the Orbiter. NOTE 2. Green LED will begin flashing. The Orbiter has built-in overcharge protection. Once fully charged, the Green LED will cycle 3.
Page 4
OFF, push and hold MASTER CONTROL for 4 NOTE the audience location. seconds, then release. The Orbiter will not connect to the receiver while charging. Once 2. Green LED will illuminate on the transmitter while ON. charged, disconnect charger and operate pendant as normal.
Need help?
Do you have a question about the Orbiter and is the answer not in the manual?
Questions and answers